Safety data sheet according to 1907/2006/EC, Article 31

Transcription

1 Page 1/6 * SECTION 1: Identification of the substance/mixture and of the company/ undertaking Product identifier Relevant identified uses of the substance or mixture and uses advised against - Application of the substance / the mixture Construction chemicals Processing aid/ Additive Details of the supplier of the safety data sheet - Manufacturer/Supplier: Ha-Be Betonchemie GmbH & Co. KG Stuevestrasse HAMELN, GERMANY - Further information obtainable from: Product Safety Department reach@ha-be.com Emergency telephone number: Only available during office hours. SECTION 2: Hazards identification Classification of the substance or mixture - Classification according to Regulation (EC) No 1272/2008 GHS08 health hazard Asp. Tox. 1 H304 May be fatal if swallowed and enters airways. - Classification according to Directive 67/548/EEC or Directive 1999/45/EC Not applicable. - Information concerning particular hazards for human and environment: The product has to be labelled due to the calculation procedure of the "General Classification guideline for preparations of the EU" in the latest valid version. - Classification system: The classification is according to the latest editions of the EU-lists, and extended by company and literature data Label elements - Labelling according to Regulation (EC) No 1272/2008 The product is classified and labelled according to the CLP regulation. - Hazard pictograms GHS08 - Signal word Danger - Hazard-determining components of labelling: Distillates (petroleum), hydrotreated light naphthenic Distillates (petroleum), hydrotreated heavy paraffinic - Hazard statements H304 May be fatal if swallowed and enters airways. - Precautionary statements P301+P310 IF SWALLOWED: Immediately call a POISON CENTER/ doctor. P331 Do NOT induce vomiting. (Contd. on page 2)

2 Page 2/6 P405 P501 Store locked up. Dispose of contents/container in accordance with local/regional/national/international regulations Other hazards - Results of PBT and vpvb assessment - PBT: Not applicable. - vpvb: Not applicable. (Contd. of page 1) SECTION 3: Composition/information on ingredients Chemical characterisation: Mixtures - Description: Mixture of substances listed below with nonhazardous additions. - Dangerous components: Void - Additional information: For the wording of the listed risk phrases refer to section 16. SECTION 4: First aid measures Description of first aid measures - After inhalation: Supply fresh air; consult doctor in case of complaints. - After skin contact: Immediately wash with water and soap and rinse thoroughly. - After eye contact: Rinse opened eye for several minutes under running water. - After swallowing: Do not induce vomiting; call for medical help immediately. Administer medicinal carbon Most important symptoms and effects, both acute and delayed Indication of any immediate medical attention and special treatment needed SECTION 5: Firefighting measures Extinguishing media - Suitable extinguishing agents: CO2, powder or water spray. Fight larger fire with alcohol resistant foam. Use fire extinguishing methods suitable to surrounding conditions. - For safety reasons unsuitable extinguishing agents: Water with full jet Special hazards arising from the substance or mixture Advice for firefighters - Protective equipment: No special measures required. SECTION 6: Accidental release measures Personal precautions, protective equipment and emergency procedures Wear protective equipment. Keep unprotected persons away Environmental precautions: Do not allow to enter sewers/ surface or ground water Methods and material for containment and cleaning up: Absorb with liquid-binding material (sand, diatomite, acid binders, universal binders, sawdust). Dispose contaminated material as waste according to item 13. Ensure adequate ventilation Reference to other sections See Section 7 for information on safe handling. See Section 8 for information on personal protection equipment. (Contd. on page 3)

3 Page 3/6 See Section 13 for disposal information. (Contd. of page 2) * SECTION 7: Handling and storage Precautions for safe handling Ensure good ventilation/exhaustion at the workplace. Prevent formation of aerosols. - Information about fire - and explosion protection: No special measures required Conditions for safe storage, including any incompatibilities - Storage: - Requirements to be met by storerooms and receptacles: No special requirements. - Information about storage in one common storage facility: Store away from oxidising agents. - Further information about storage conditions: None Specific end use(s) SECTION 8: Exposure controls/personal protection - Additional information about design of technical facilities: No further data; see item Control parameters - Ingredients with limit values that require monitoring at the workplace: The product does not contain any relevant quantities of materials with critical values that have to be monitored at the workplace. - Additional information: The lists valid during the making were used as basis Exposure controls - Personal protective equipment: - General protective and hygienic measures: Keep away from foodstuffs, beverages and feed. Wash hands before breaks and at the end of work. Avoid close or long term contact with the skin. Do not inhale gases / fumes / aerosols. - Respiratory protection: In case of brief exposure or low pollution use respiratory filter device. In case of intensive or longer exposure use self-contained respiratory protective device. - Protection of hands: The glove material has to be impermeable and resistant to the product/ the substance/ the preparation. Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture. Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation - Material of gloves The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application. - Penetration time of glove material The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed. - Eye protection: Goggles recommended during refilling - Body protection: Protective work clothing (Contd. on page 4)

4 Page 4/6 (Contd. of page 3) * SECTION 9: Physical and chemical properties Information on basic physical and chemical properties - General Information - Appearance: Form: Fluid Colour: Light yellow - Odour: Mineral-oil-like - Change in condition Melting point/melting range: Undetermined. Boiling point/boiling range: Undetermined. - Flash point: > 100 C - Danger of explosion: Product does not present an explosion hazard. - Density at 20 C: 0.89 g/cm³ - Solubility in / Miscibility with water: Not miscible or difficult to mix. - Viscosity: Dynamic: Not determined. Kinematic: Not determined Other information SECTION 10: Stability and reactivity Reactivity Chemical stability - Thermal decomposition / conditions to be avoided: No decomposition if used according to specifications Possibility of hazardous reactions Reacts with strong oxidising agents Conditions to avoid Incompatible materials: Hazardous decomposition products: No dangerous decomposition products known. * SECTION 11: Toxicological information Information on toxicological effects - Acute toxicity - LD/LC50 values relevant for classification: Distillates (petroleum), hydrotreated light naphthenic Oral LD50 > 5000 mg/kg (rat) (OECD 401) Dermal LD50 > 5000 mg/kg (rabbit) (OECD 402) Inhalative LC50 > 5.53 mg/l (rat) (4 h) Distillates (petroleum), hydrotreated heavy paraffinic Oral LD50 > 5000 mg/kg (rat) (OECD 401) Dermal LD50 > 5000 mg/kg (rabbit) (OECD 402) Inhalative LC50 > 5.53 mg/l (rat) (4 h) - Primary irritant effect: - Skin corrosion/irritation Based on available data, the classification criteria are not met. - Serious eye damage/irritation Based on available data, the classification criteria are not met. - Respiratory or skin sensitisation Based on available data, the classification criteria are not met. (Contd. on page 5)

5 Page 5/6 - CMR effects (carcinogenity, mutagenicity and toxicity for reproduction) - Germ cell mutagenicity Based on available data, the classification criteria are not met. - Carcinogenicity Based on available data, the classification criteria are not met. - Reproductive toxicity Based on available data, the classification criteria are not met. - STOT-single exposure Based on available data, the classification criteria are not met. - STOT-repeated exposure Based on available data, the classification criteria are not met. - Aspiration hazard May be fatal if swallowed and enters airways. (Contd. of page 4) * SECTION 12: Ecological information Toxicity - Aquatic toxicity: Distillates (petroleum), hydrotreated light naphthenic IC50 akut > 100 mg/l (Alg) (OECD Stunden) LC50 akut > 100 mg/l (Fis) (OECD Stunden) Distillates (petroleum), hydrotreated heavy paraffinic IC 50 > 100 mg/l (Alg) (OECD Stunden) LC50 akut > 100 mg/l (Fis) (OECD Stunden) Persistence and degradability Bioaccumulative potential Mobility in soil - Additional ecological information: - General notes: Do not allow undiluted product or large quantities of it to reach ground water, water course or sewage system Results of PBT and vpvb assessment - PBT: Not applicable. - vpvb: Not applicable Other adverse effects SECTION 13: Disposal considerations Waste treatment methods - Recommendation Must not be disposed together with household garbage. Do not allow product to reach sewage system. When storing used mineral oil products, ensure that the categories for waste oil and mixing instructions are observed. Delivery of waste oil to offically authorised collectors only. - Uncleaned packaging: - Recommendation: Empty contaminated packagings thoroughly. They may be recycled after thorough and proper cleaning. SECTION 14: Transport information UN-Number - ADR, IMDG, IATA Void UN proper shipping name - ADR, IMDG, IATA Void Transport hazard class(es) - ADR, IMDG, IATA - Class Void (Contd. on page 6)

6 Page 6/ Packing group - ADR, IMDG, IATA Void Environmental hazards: - Marine pollutant: No Special precautions for user Not applicable Transport in bulk according to Annex II of Marpol and the IBC Code Not applicable. (Contd. of page 5) - Transport/Additional information: Not dangerous according to the above specifications. * SECTION 15: Regulatory information Safety, health and environmental regulations/legislation specific for the substance or mixture Chemical safety assessment: A Chemical Safety Assessment has not been carried out. SECTION 16: Other information This information is based on our present knowledge. However, this shall not constitute a guarantee for any specific product features and shall not establish a legally valid contractual relationship. - Abbreviations and acronyms: Asp. Tox. 1: Aspiration hazard, Hazard Category 1