SAFETY DATA SHEET. FOAMSEAL Hurricane Adhesive - Part B. MANUFACTURER 24 HR. EMERGENCY TELEPHONE NUMBERS ITW Polymers Sealants North America

Transcription

1 Page 1 of 6 1. PRODUCT AND COMPANY IDENTIFICATION PRODUCT NAME: MANUFACTURER 24 HR. EMERGENCY TELEPHONE NUMBERS ITW Polymers Sealants North America CHEMTREC (US Transportation): (800) Air Station Industrial Park Rockland, MA Product Stewardship: (781) COMMENTS: FOAMSEAL is a registered trademark of Illinois Tool Works, Inc. 2. HAZARDS IDENTIFICATION GHS CLASSIFICATIONS Health: Target Organ Toxicity (Repeated exposure), Category 2 GHS LABEL Exclamation mark SIGNAL WORD: WARNING HAZARD STATEMENTS H373: May cause damage to organs through prolonged or repeated exposure. H319: Causes serious eye irritation. H315: Causes skin irritation. PRECAUTIONARY STATEMENT(S) Prevention: P260: Do not breathe dust/fume/gas/mist/vapours/spray. Response: P314: Get medical advice/attention if you feel unwell. Disposal: P501: Dispose of contents/container according to local, regional, national and international regulations. POTENTIAL HEALTH EFFECTS EYES: May cause eye irritation upon contact. SKIN: May cause skin irritation. INGESTION: May cause damage to mucous membranes if swallowed. INHALATION: Short-term harmful health effects are not expected from vapor generated at ambient temperatures. ROUTES OF ENTRY: Eye and Skin Contact, Inhalation and Ingestion

2 Page 2 of 6 3. COMPOSITION / INFORMATION ON INGREDIENTS Chemical Name Wt.% CAS Polyalkylene oxide polyol < Polyether Polyol < Polyoxyalkyleneamine < N, N Dimethylcyclohexyl Amine < Silicone Surfactant < 2 Mixture 4. FIRST AID MEASURES EYES: Immediately flush eyes with plenty of tempered water (at least minutes) lifting upper and lower eye lids occasionally. Get immediate medical attention. SKIN: Immediately flush skin with plenty of water. Remove clothing. Get medical attention immediately. Wash clothing separately before reuse. INGESTION: Do not induce vomiting. Get medical attention immediately. Never give anything by mouth to an unconscious person. INHALATION: Remove to fresh air. If not breathing, give artificial respiration or give oxygen by trained personnel. Seek immediate medical attention. 5. FIRE FIGHTING MEASURES FLAMMABLE CLASS: Not Applicable EXTINGUISHING MEDIA: Water spray, carbon dioxide, dry chemical or foam. EXPLOSION HAZARDS: Decomposition products may cause a health hazard. FIRE FIGHTING PROCEDURES: As in any fire, wear self-contained breathing apparatus pressure-demand, (MSHA/NIOSH approved or equivalent) and full protective gear. After water evaporates, remaining material will burn. SENSITIVE TO STATIC DISCHARGE: None Expected. HAZARDOUS DECOMPOSITION PRODUCTS: Carbon dioxide, carbon monoxide, nitrogen oxide, ammonia, aldehydes, ketones, organic fragments 6. ACCIDENTAL RELEASE MEASURES SMALL SPILL: Dike area to contain spill. Take precautions as necessary to prevent contamination of ground and surface waters. Recover spilled material on absorbent, such as sawdust or vermiculite, and sweep into closed containers for disposal. Do not flush to sewer. If area of spill is porous, remove as much contaminated earth and gravel, etc. as necessary and place in closed containers for disposal. Only those persons who are adequately trained, authorized, and wearing the appropriate personal protective equipment (PPE) should participate in spill response and clean-up. LARGE SPILL: Keep spectators away. Only those persons who are adequately trained, authorized and wearing the required personal protective equipment (PPE) should participate in spill response and clean-up. Know and prepare for spill response before using or handling this product. Dike and contain spill with inert material (e.g. sand, earth). Transfer liquids to covered and labeled containers for disposal. Use appropriate PPE. Place

3 Page 3 of 6 absorbent diking materials in covered containers for disposal. Prevent contamination of sewers, streams, and groundwater with spilled material or used absorbent. 7. HANDLING AND STORAGE GENERAL PROCEDURES: For professional or industrial use only. Follow label instructions. Keep out of the reach of children. Not for consumption. No smoking. Do not breathe vapors. Avoid contact with body. Empty containers must not be washed and re-used for any purpose. Contact lens wearers must wear protective eye wear around chemical vapors and liquid. Wash hands thoroughly after handling. To prevent build-up of vapors, use adequate natural and/or mechanical ventilation (e.g. open all windows and doors to achieve cross ventilation). HANDLING: Follow all SDS/label precautions even after container is emptied because they may retain product residues. Containers should be tightly closed to prevent contamination with foreign materials and moisture. Employee education and training in the safe handling of this product are required under the Federal OSHA Hazard Communication Standard. Avoid contact of liquid with eyes and prolonged skin exposure. STORAGE: Keep container closed when not in use. Store in a dry, well ventilated area, out of the sun and away from ignition sources. Do not remove or deface label. Prevent water or moist air from entering container. STORAGE TEMPERATURE: 18.3 C (65 F) Minimum to 35 C (95 F) Maximum SHELF LIFE: 6 months from manufacture date 8. EXPOSURE CONTROLS / PERSONAL PROTECTION EXPOSURE GUIDELINES OSHA HAZARDOUS COMPONENTS (29 CFR ) EXPOSURE LIMITS OSHA PEL ACGIH TLV Chemical Name ppm mg/m 3 ppm mg/m 3 Polyalkylene oxide polyol Polyether Polyol Polyoxyalkyleneamine N, N Dimethylcyclohexyl Amine Silicone Surfactant Footnotes: 1. NL = Not Listed ENGINEERING CONTROLS: Natural ventilation should be adequate under normal conditions. PERSONAL PROTECTIVE EQUIPMENT

4 Page 4 of 6 EYES AND FACE: Wear safety glasses with side shields, goggles, or a full-face shield. Do not wear contact lenses. SKIN: Wear chemical resistant gloves such as latex, butyl rubber, nitrile rubber, polyvinyl alcohol. Wear chemical protective clothing & boots to prevent repeated or prolonged skin contact. RESPIRATORY: This material does not have established exposure limits. Wear a positive pressure air-supplied respirator in situations where there may be potential for airborne exposure. WORK HYGIENIC PRACTICES: Use good hygiene practices when handling this material. Wash hands thoroughly after use. 9. PHYSICAL AND CHEMICAL PROPERTIES PHYSICAL STATE: Liquid ODOR: Slight Amine Odor COLOR: Amber ph: Not Determined PERCENT VOLATILE: 2.4 FLASHPOINT AND METHOD: Not Determined FLAMMABLE LIMITS: Not Determined AUTOIGNITION TEMPERATURE: Not Applicable VAPOR PRESSURE: Not Determined VAPOR DENSITY: > 1 (Air=1) BOILING POINT: Not Determined FREEZING POINT: Not Determined MELTING POINT: Not Determined SOLUBILITY IN WATER: Partially Soluble EVAPORATION RATE: Not Determined DENSITY: 8.67 lbs/gal PARTICLE SIZE: Not Determined SPECIFIC GRAVITY: 1.04 VISCOSITY: Not Determined MOLECULAR WEIGHT: Not Determined (VOC): gr/l EPA Method 24 VOC 10. STABILITY AND REACTIVITY REACTIVITY: Yes HAZARDOUS POLYMERIZATION: Product will not undergo polymerization. STABILITY: Stable. POSSIBILITY OF HAZARDOUS REACTIONS: None Expected. HAZARDOUS DECOMPOSITION PRODUCTS: Carbon monoxide, carbon dioxide, nitrogen oxide, isocyanate vapors and mist, traces of HCN. If vapor heated with peroxides present, violent decomposition can occur. INCOMPATIBLE MATERIALS: Alkali or alkaline earth metals, strong acids, copper, brass, elastomers

5 Page 5 of TOXICOLOGICAL INFORMATION ACUTE Chemical Name ORAL LD 50 (rat) DERMAL LD 50 (rabbit) INHALATION LC 50 (rat) Polyalkylene oxide polyol > 2000 mg/kg > 2000 mg/kg No data Polyether Polyol Polyoxyalkyleneamine N, N Dimethylcyclohexyl Amine > 5000 mg/kg (rats) 1100 mg/kg (rats) 272 mg/kg (rats) > 2000 mg/kg (rabbits) 1555 mg/kg (rat) > 400 mg/kg (rabbits) > 200 mg/l (1-hr dose) No data 9 mg/l (1-hr dose) Silicone Surfactant No data No data No data IRRITATION: Mild to moderate eyes and skin irritation. 12. ECOLOGICAL INFORMATION ENVIRONMENTAL DATA: This product contains components that may be harmful to aquatic organisms and may cause long term adverse effects in the aquatic environment. ECOTOXICOLOGICAL INFORMATION: Contains components that are potentially toxic to freshwater and saltwater ecosystems. 13. DISPOSAL CONSIDERATIONS DISPOSAL METHOD: Dispose of in accordance with all local, state and federal regulations. 14. TRANSPORT INFORMATION DOT (DEPARTMENT OF TRANSPORTATION) PROPER SHIPPING NAME: Not Regulated PACKING GROUP: N/A 15. REGULATORY INFORMATION UNITED STATES SARA TITLE III (SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT) FIRE: No PRESSURE GENERATING: No REACTIVITY: No ACUTE: Yes CHRONIC: No 313 REPORTABLE INGREDIENTS: None TSCA (TOXIC SUBSTANCE CONTROL ACT)

6 Page 6 of 6 Chemical Name CAS Polyalkylene oxide polyol Polyether Polyol Polyoxyalkyleneamine N, N Dimethylcyclohexyl Amine Silicone Surfactant Mixture CANADA WHMIS HAZARD SYMBOL AND CLASSIFICATION Toxic 16. OTHER INFORMATION Date Revised: 11/17/2015 INFORMATION CONTACT: (781) REVISION SUMMARY: This MSDS replaces the 11/17/2015 MSDS. Revised: Section 1: Date Issued. HMIS RATING HEALTH 2 FLAMMABILITY 1 PHYSICAL HAZARD 0 PERSONAL PROTECTION B NFPA CODES GENERAL STATEMENTS: Keep out of reach of children For professional or industrial use only MANUFACTURER DISCLAIMER: This document may be used to comply with OSHA's Hazardous Communication Standard, 29 CFR To the best of our knowledge, the information contained in this SDS is accurate. It is intended to assist the user in his/her evaluation of the product's hazards and safety precautions to be taken in its use. The data in this SDS relate only to the specific material designated herein. We do not assume liability for the use of, or reliance on this information, nor do we guarantee its accuracy or completeness. This information is furnished without warranty, expressed or implied, except that it is accurate to the best knowledge of ITW Polymers Sealants North America. The data on this sheet relates only to the specific material designated herein. ITW Polymers Sealants North America assumes no legal responsibility for use or reliance upon these data.