SDS: Decorator Acrylic Ultra Low Sheen Page 1 of 5 Safety Data Sheet SECTION 1. IDENTIFICATION OF THE MATERIAL AND SUPPLIER Product identifier Variants - Product code(s) 624 Proper shipping name - Decorator Acrylic Ultra Low Sheen Recommended use Manufacture / Importer details Emergency phone numbers Free call Phone Fax Poisons Information Centre SECTION 2. Waterborne acrylic paint Resene Paints (Australia) Limited. 7 Production Avenue, Molendinar. Queensland. 4214. Available Monday Friday, 8:00 a.m. 5:00 p.m. 1800 738 383 07 3287 0222 07 3287 0227 131126 [available 24 hours] HAZARDS IDENTIFICATION Classification of the hazardous chemical or mixture according to the criteria of Safe Work Australia GHS Classification: Sensitisation Skin Category 1. Label elements Signal word Hazard statements H317 Exclamation Mark WARNING May cause an allergic skin reaction. Precautionary statements: Prevention P280 Wear protective gloves. P272 Contaminated work clothing should not be allowed out of the workplace. P261 Avoid breathing fume, vapours and sanding dust. Precautionary statements: Response P321 Specific treatment (see advice on this label). P302 + P352 IF ON SKIN: Wash with plenty of soap and water. P333+ P313 If skin irritation or rash occurs: Get medical advice/attention. P363 Wash contaminated clothing before reuse. Precautionary statements: Storage - - Precautionary statements: Disposal P501 Dispose of contents/container in accordance with local Regulations.
SDS: Decorator Acrylic Ultra Low Sheen Page 2 of 5 SECTION 3. COMPOSITION AND INFORMATION ON INGREDIENTS Ingredients Name CAS % [weight] Acrylic resin Not known 10 - < 30 Water 7732-18-5 30 60 Mixed terpineols Not known < 10 Proprietary ingredients - To 100 SECTION 4. FIRST AID MEASURES Description of necessary first aid measures Ingestion Eye contact Drink 1 or 2 glasses of water. Consult a physician if necessary. Never give anything by mouth to an unconscious person. Rinse with plenty of water. If eye irritation persists, consult a specialist. Skin contact Inhalation First Aid facilities Symptoms caused by exposure Medical attention and special treatment Extinguisher SECTION 5. Hazards from combustion products Special protective precautions and equipment for fire fighters Hazchem code Flush skin with plenty of water while removing contaminated clothing and shoes. Wash skin with soap if available. Seek medical attention if irritation persists or if a rash develops. Move to fresh air. Safety shower and eye wash facilities. Contact with skin or eyes may cause irritation. Contact with the skin may cause an allergic skin reaction. Persons with predisposed skin conditions or those known to be sensitised to terpineols should take extra precautions or avoid using this product. Basic life support. Treat symptomatically. FIRE FIGHTING MEASURES Water based product. Choose extinguishing media suitable for surroundings. Oxides of Carbon and Nitrogen. Material can splatter above 100 C. Polymer film can burn. Do not allow contaminants and water from fire fighting to enter drains or water course. Not Specified SECTION 6. Emergency procedures Methods and materials for containment and clean up. ACCIDENTAL RELEASE MEASURES In confined areas wear protective equipment. Keep spectators away and avoid breathing dust or vapours. Floor may be slippery, use care to avoid falling. Minor spills Contain and absorb small quantities with vermiculate or other absorbent material. Wipe up. Collect residues in a waste container. Major spills Prevent, by any means available, spillage from entering drains or water course. Contain spill with sand, earth or vermiculite. Transfer liquid to containers for recovery or disposal.
SDS: Decorator Acrylic Ultra Low Sheen Page 3 of 5 SECTION 7. Precautions for safe handling Conditions for safe storage including any incompatibilities SECTION 8. HANDLING AND STORAGE Avoid damaging containers. Keep lids on containers when not in use. People handling this product should wash their hands and face before eating and/or smoking. Handle containers carefully to prevent damage and/or spillage. Storage temperatures: Max: 40 C, Min: 1 C. Avoid excessive changes n temperature. Avoid storing with strong oxidisers, acids and alkalis EXPOSURE CONTROLS AND PERSONAL PROTECTION Australian national No exposure standard has been established for this product or the components. exposure standards Component TWA STEL ppm mg/m 3 ppm mg/m 3 Peak limitations Biological monitoring Engineering controls No peak limitations allocated. Not required. Use in a well ventilated area. General exhaust is adequate under normal operating conditions. If the risk of overexposure exists, wear an approved respirator. Individual protection measures including Personal Protection Equipment (PPE) Eye and face protection Wear safety glasses or goggles. Avoid wearing contact lenses. Contact lenses pose a special hazard; soft lenses may concentrate and absorb irritants. Skin protection Protective clothing Respiratory protection SECTION 9. Wear chemical protective gloves, e.g. Nitrile or nitrile-butatoluene rubber. Do not use cotton, leather, PVC, rubber or polyethylene gloves as they will absorb the resin. Hypersensitive persons should wear protective clothing, gloves and use protective cream on face, hands and all exposed areas. Standard issue work wear. Wear safety footwear. Selection of the Class and Type of respirator will depend on the level of confinement of the contamination. The local concentration of material, quantity and conditions of use determine the type of personal protective equipment required. Refer to AS1716 for selection of an appropriate respirator. PHYSICAL AND CHEMICAL PROPERTIES Appearance White viscous liquid Odour Amine ph 7 10 Vapour pressure Vapour density Boiling point 100ºC Flash point Solubility Soluble Density 1.4 UEL LEL Volatile by weight 35 %
SDS: Decorator Acrylic Ultra Low Sheen Page 4 of 5 SECTION 10. STABILITY AND REACTIVITY Chemical stability Conditions to avoid Incompatible materials Hazardous decomposition products Hazardous reactions Product is considered stable under normal storage and handling conditions. Presence of incompatible materials. Strong oxidisers, acids and alkalis. Oxides of carbon and nitrogen, and smoke. Hazardous polymerisation will not occur. SECTION 11. TOXICOLOGICAL INFORMATION No data available for this product. Acute: Direct contact with the eye may produce transient discomfort characterised by tearing or conjunctival redness. Not expected to cause irritation to the skin or respiratory tract. Chronic: There is limited evidence that skin contact with this product may cause a sensitisation reaction in some individuals. SECTION 12. ECOLOGICAL INFORMATION No data available for this product. No data available for product ingredients. This product should not be allowed to enter drains or water courses. SECTION 13. Disposal methods and containers Special precautions for landfill or incineration SECTION 14. UN Number UN Proper shipping name Class Subsidiary risk Packing Group Special precautions for user Hazchem Code SECTION 15. DISPOSAL CONSIDERATIONS Consult State Land Waste Management Authority for disposal. Incinerate residue at an approved site. Recycle containers if possible, or dispose of in an approved landfill. TRANSPORT INFORMATION Not specified Water Based Paint. Non Hazardous. Not restricted None N.O.S. - Not specified. REGULATORY INFORMATION SUSMP: Not a scheduled poison.
SDS: Decorator Acrylic Ultra Low Sheen Page 5 of 5 SECTION 16. Date of Preparation: 7 th October 2015 Supersedes: 18 th May 2010 Literature references. Abbreviations: OTHER INFORMATION Preparation of Safety Data Sheets for Hazardous Chemicals. Safe Work Australia. 2011 Code of Practice. Australian Dangerous Goods Code 7 th Edition. MSDS s for individual raw materials. NZ SDS for this product. Globally Harmonized System of Classification and Labelling of Chemicals (GHS). Third Revised Edition. United Nations. New York and Geneva, 2009. ADG TWA STEL CAS Number Australian Code for the Transport of Dangerous Goods by Road & Rail Time weighted average Short term exposure limit Chemical Abstract Service registry number Safety data sheets are updated frequently. Please ensure that you have a current copy. The information contained herein is based on data considered accurate and reliable to the best of our knowledge and belief as of the date compiled. However no warranty is expressed or implied regarding the accuracy of these data or the results to be obtained from the use hereof. Resene Paints (Australia) Limited assumes no responsibility for personal injury or property damage to vendors, users or third parties caused by the material, Such users or vendors assume all risks associated with the use of the material. It is the users responsibility to satisfy themselves as to the suitability and completeness of the information for their own particular use. The user must determine whether the use of the information and data is in accordance with local laws and regulations. END OF SDS