ADB Air Pump. Single Circuit Air Drive Booster Pmax:6kg/cm A ISO B P T Product Introduction The booster pump is driven by air to output hydraulic pressure for apower source for hydraulic cylinder. Its flow rate is bigger than that ofa conventional booter. Continuous pressure boosting and nolimitation of booster stroke for the acting cylinder. Pressure adjustment is made by an air pressure regulation valve.once pressure reaches the desired value, drive stops immediately. Incase pressure drops, the pump will compensate pressureautomatically. The series is especially ideal for long time hydraulicclamping application. Also features energy saving, no oil temperaturegrowth, economical and convenient. A Type: Equipped with ISO approved manifold and solenoid valve.applicable for single-acting or double-acting hydraulic cylinder. B Type: Equipped with pipe block with P.T ports, permitting forconnecting to a manual contort valve for operation control. Reduced oil tank volume for space saving and convenient installation. Specification Fluid Filtered air Max operation pressure 6kg/cm Boost pressure rate 6 1 44 Air pressure supply 5kg/cm 16 1 5 3 Hydraulic fluid expelled l/min Oil tank capacity 5 l Oil ISO-VG6 Order Code ADB- A - B - AC11V - MBRV 1 3 4 5 6 1 3 4 5 6 Series Boost pressure rate Control type Direction change valve type Coil type Quantity of pressure reduving valve A B ADB 6 1 44 ISO Manifold, magnet valve P.T Distributing tube seat P.T. port Single Head : B- Double Head : D- 3C- AC11V ACV DC4V MBRV-P TAIWAN AMAC CLAMP INDUSTRIAL CO., LTD. TEL:6-4-15 11 FAX:6-4-15
ADB Air Pump. Single Circuit Air Drive Booster Pmax:6kg/cm (311) 5 1 ISO-VG6,, (36) 345,,,,, 16 Ø9-3 holes at back & bottom,,, Notice 3 Use ISO-VG6 hydraulic oil. Be sure to fill proper amount of hydraulic oil into the oil tank before operation. Periodically inspect hydraulic oil quality to prevent affection on normal operation and parts life. In case air system can t work, remove the air valve but do not break down. Use an air gan to clean the internal direction change ports. There is a thin type bronze silencer on the aluminum body of air cylinder. If it is blocked by suction of powder dust, it may impede the motion of the piston of air cylinder. When such problem occurs, remove it for cleaning or replacing. If air system works continuously, but hydraulic pressure can t boost, it means oil seal is damaged causing internal leakage. TAIWAN AMAC CLAMP INDUSTRIAL CO., LTD. TEL:6-4-15 11 FAX:6-4-15
ADB Air Pump. Three Circuit Air Drive Booster Pmax:6kg/cm P MBRV-P EP-FA PS-1: ~kg PS-: 5~kgg Product Introduction The body of the booster cylinder has the same actuating function as the single circuit. The output hydraulic pressure includes three circuit. The P port on each circuit is equipped with a single direction valve, so that each circuit can work individually. It is applicable for automated clamp in multi-circuit, which can independently control hydraulic cylinder of clamp. Optional Accessories: Modular pressure reducing valve MBRV-P Fluid level switch in oil tank EP-FA Pressure sensor PS-1: ~kg PS-: 5~kg Specification Fluid Filtered air Max operation pressure 6 kg/cm Boost pressure rate 6 1 44 Air pressure supply 5kg/cm 16 1 5 3 Hydraulic fluid expelled l/min Oil tank capacity 1 l Oil ISO-VG6 Order Code ADB- A3 - B - AC11V - MBRV 1 3 4 5 6 1 3 4 5 6 Series Boost pressure rate Control type Direction change valve type Coil type Quantity of pressure reduving valve ADB 6 1 44 ISO Three-circuit manifold plate with ISO specification. Single Head : B- Double Head : D- 3C- AC11V ACV DC4V MBRV1 MBRV MBRV3 A, A3 Remark: A two circuits and A3 three circuits that commonly use an oil tank and manifold plate. TAIWAN AMAC CLAMP INDUSTRIAL CO., LTD. TEL:6-4-15 11 FAX:6-4-15
5 5 5 1 1 1 ADB Air Pump. Three Circuit Air Drive Booster Pmax:6kg/cm 35 (41) 5 (463) 35 (41) 1 33 13 4 35 4-Ø9~13x33 holes at back & bottom 33 13 33 4-Ø9~13x33 holes at back & bottom 33 TAIWAN AMAC CLAMP INDUSTRIAL CO., LTD. TEL:6-4-15 11 FAX:6-4-15
ADB Air Pump. Four Circuit Air Drive Booster Pmax:6kg/cm P MBRV-P EP-FA PS-1: ~kg PS-: 5~kg Product Introduction The body of the booster cylinder has the same actuating function as the single circuit. The output hydraulic pressure includes four circuit. The P port on each circuit is equipped with a single direction valve, so that each circuit can work individually. It is applicable for automated clamp in multi-circuit, which can independently control hydraulic cylinder of clamp. Optional Accessories: Modular pressure reducing valve MBRV-P Fluid level switch in oil tank EP-FA Pressure sensor PS-1: ~kg PS-: 5~kg Specification Fluid Filtered air Max operation pressure 6 kg/cm Boost pressure rate 6 1 44 Air pressure supply 5kg/cm 16 1 5 3 Hydraulic fluid expelled l/min Oil tank capacity 1 l Oil ISO-VG6 Order Code ADB- A4 - B - DC4V - MBRV 1 3 4 5 6 1 3 4 5 6 Series Boost pressure rate Control type Direction change valve type Coil type Quantity of pressure reduving valve ADB 6 1 44 ISO Four-circuit manifold plate with ISO specification. Single Head : B- Double Head : D- 3C- AC11V ACV DC4V MBRV1 MBRV MBRV3 MBRV4 TAIWAN AMAC CLAMP INDUSTRIAL CO., LTD. TEL:6-4-15 11 FAX:6-4-15
5 5 1 ADB Air Drive Booster Air Pump. Four Circuit Pmax:6kg/cm 4 (46) 1 5 5 1 (463) 33 13 4-Ø9~13x3 holes at back & bottom 3 TAIWAN AMAC CLAMP INDUSTRIAL CO., LTD. TEL:6-4-15 11 FAX:6-4-15