Practical Application of Turn Lane Design Criteria in Developing Suburban & Urban Corridors

Similar documents
Figure 1: Vicinity Map of the Study Area

KDOT Access Management Policy (AMP)

TRAFFIC AND SAFETY NOTE 608A. Spacing for Commercial Drives and Streets. To Promote a Uniform Practice in Determining Access Spacing

Access Location, Spacing, Turn Lanes, and Medians

Traffic Impact Analysis Walton Acres at Riverwood Athletic Club Clayton, NC

Issues Relating to the Geometric Design of Intersections Vergil G. Stover

Roadway Design Manual

Chapter Twenty-eight SIGHT DISTANCE BUREAU OF LOCAL ROADS AND STREETS MANUAL

Design of Turn Lane Guidelines

Safety Impacts: Presentation Overview

Update to DOTD Roundabout Design Policy

Traffic Impact Study WestBranch Residential Development Davidson, NC March 2016

THE FUTURE OF THE TxDOT ROADWAY DESIGN MANUAL

SUPERSTREETS IN TEXAS. ITS Texas Annual Meeting San Marcos, Texas Session 6A - Operations November 11, 2011

Vehicular turning and path of travel with a proposed curb bulb on the southwest corner of Mount Diablo Boulevard and Dewing Avenue.

Transportation Impact Study for Abington Terrace

Driveway Design Criteria

Traffic Academy: IJS & IMS FAQ/RULES OF THUMB

Access Management in the Vicinity of Intersections

INDEX. Geometric Design Guide for Canadian Roads INDEX

Roundabout Prequalification Training. March 11, 2015

FORM A PASCO COUNTY ACCESS CONNECTION PERMIT APPLICATION

I-95 Northbound at US 1 (Exit 126) Design and Study Final Report

Dr. Naveed Anwar Executive Director, AIT Consulting Affiliated Faculty, Structural Engineering Director, ACECOMS

Glenn Avenue Corridor Traffic Operational Evaluation

TRAFFIC IMPACT STUDY And A TRAFFIC SIGNAL WARRANT ANALYSIS FOR A SENIOR LIVING AND APARTMENT DEVELOPMENT

Traffic Signal Redesign 50% Design Report

Progress Report on the Design and Planning of an Infrastructure Improvement Project for the Sunnyside TIF District (Phase II)

Traffic Engineering and Highway Safety Bulletin June Overview

Existing Conditions. Date: April 16 th, Dan Holderness; Coralville City Engineer Scott Larson; Coralville Assistant City Engineer

Design Criteria. Design Criteria

Subject: Use of Pull-off Areas in Work Zones Page: 1 of 13. Brief Description: Guidance for the use and placement of pull-off area in work zones.

2009 PE Review Course Traffic! Part 1: HCM. Shawn Leight, P.E., PTOE, PTP Crawford Bunte Brammeier Washington University

BASIC FREEWAY CAPACITY STUDIES Definitions

Geometric Design Tables

133 rd Street and 132 nd /Hemlock Street 132 nd Street and Foster Street MINI ROUNDABOUTS. Overland Park, Kansas

T R A N S P O R T A T I O N M E M O R A N D U M

MUNICIPALITY OF ANCHORAGE Traffic Department MEMORANDUM

Traffic Impact Analysis Chatham County Grocery Chatham County, NC

Multilane Highways 54

REDEVELOPMENT TRAFFIC IMPACT STUDY

Troutbeck Farm Development

Offset Single Point Interchange I-25 at Rio Bravo Boulevard Albuquerque, New Mexico

Traffic Impact Study Little Egypt Road Development Denver, North Carolina June 2017

MEETING FACILITY 2901 GIBFORD DRIVE CITY OF OTTAWA TRANSPORTATION BRIEF. Prepared for: Holiday Inn Express 2881 Gibford Drive Ottawa, ON K1V 2L9

Access Management Design Standards for Entrances and Intersections

DESIGN MEMORANDUM WITH DESIGN EXCEPTIONS SP SP

Median Design. Course No: C Credit: 4 PDH. Debra Kennaugh, P.E.

10.0 CURB EXTENSIONS GUIDELINE

TRAFFIC IMPACT ANALYSIS

A Comprehensive HCM 2010 Urban Streets Analysis Using HCS 2010 US 31W in Elizabethtown, KY

400 Intersection Design

400 Intersection Design

Transportation Advisory Board

3.0 ACCESS CONTROL PLAN - HARMONY ROAD (SH68)

TABLE OF CONTENTS LIST OF FIGURES. Figure Title

APPENDIX B(2) MULTIMODAL DESIGN STANDARDS FOR MIXED-USE URBAN CENTERS

Walton Acres at Riverwood Athletic Club Clayton, North Carolina

CHAPTER 1 STANDARD PRACTICES

INDUSTRIAL BUILDING 3009 HAWTHORNE ROAD CITY OF OTTAWA TRANSPORTATION OVERVIEW REVISED. Prepared for: Canada Inc.

List of Attachments. Location Map... Site Plan... City of Lake Elsinore Circulation Element... City of Lake Elsinore Roadway Cross-Sections...

Recommended Roadway Plan Section 2 - Land Development and Roadway Access

TABLE OF CONTENTS TABLE OF CONTENTS... I APPENDICES... III LIST OF EXHIBITS... V LIST OF TABLES... VII LIST OF ABBREVIATED TERMS...

Basic Freeways and Multilane Highways (LOS) CIVL 4162/6162

TRAFFIC SIGNAL WARRANT STUDY

122 Avenue: 107 Street to Fort Road

TRANSPORTATION IMPACT STUDY PROPOSED RIVERFRONT 47 MIXED USE DEVELOPMENT

TRANSPORTATION FACILITY PLANNING Waugh Chapel Road Maytime Drive to New Market Lane

MEMORANDUM. Our project study area included the following locations:

WYDOT DESIGN GUIDES. Guide for. Non-NHS State Highways

Roadway Design Manual

Making Great Urban Streets Confessions of a Highway Engineer. Timothy R. Neuman.. P.E. Chief Highway Engineer CH2M HILL

3-13 UFC - GENERAL PROVISIONS AND GEOMETRIC DESIGN FOR ROADS, STREETS, WALKS, AND OPEN

TRAFFIC STUDY GUIDELINES Clarksville Street Department

How Might Connected Vehicles and Autonomous Vehicles Influence Geometric Design? October 10, 2017

Transportation Knowledge

Highway Capacity and LOS. Reading Assignment: pgs

GWINNETT COUNTY DEPARTMENT OF TRANSPORTATION

Appendix B. Environmental Resource Technical Memorandum. Assessment on Travel Pattern and Access Impacts

Traffic Circulation Study for Neighborhood Southwest of Mockingbird Lane and Airline Road, Highland Park, Texas

Unit 7 Speed, Travel Time and Delay Studies

Holland Tunnel Exit in NJ

GDOT Elements of Design. Course ID: GDOT PDH Credits

Designing with the Railroad

THIS PAGE LEFT BLANK INTENTIONALLY

Roadway Vertical Alignments

QUICKIE C STORE AND GAS BAR 1780 HERON ROAD OTTAWA, ONTARIO TRANSPORTATION BRIEF. Prepared for:

WYDOT DESIGN GUIDES. Guide for. NHS Arterial (Non-Interstate)

A Traffic Operations Method for Assessing Automobile and Bicycle Shared Roadways

Retrofitting Urban Arterials into Complete Streets

Design Considerations for Complete Streets. The Kiewit Center for Infrastructure and Transportation

Shawn Leight, P.E., PTOE, PTP CBB Transportation Engineers + Planners ITE International President Washington University

Roundabouts in a System of Intersections

Best Practices for the Design and Operation of Reduced Conflict Intersections

THE INSTALLATION OF PRE-SIGNALS AT RAILROAD GRADE CROSSINGS

Access Management Benefits & Techniques. Access Management Workshop June 2, 2006

September 2008 REVISIONS (1) SYMMETRICAL VERTICAL CURVE EQUATIONS 12.5(12) VERTICAL CURVE COMPUTATIONS 12.5(14) TURNING LANE LENGTHS 15.

American Fork City Access Management Manual

Off-road Trails. Guidance

MEMORANDUM. Charlotte Fleetwood, Transportation Planner

Transcription:

Practical Application of Turn Lane Design Criteria in Developing Suburban & Urban Corridors Presented by Gilmer D. Gaston, P.E., PTOE October 14, 2014 San Antonio Austin Houston Fort Worth Dallas

When are Turn Lanes Needed (Required) Access Management Manual Right Turn Deceleration Lanes (Table 2-3) are needed: Speed > 45 mph & Right Turn Volume > 50 vph Speed <= 45 mph & Right Turn Volume > 60 vph Other factors Crash experience Heavy peak flow Large truck volumes Limited sight distance Left Turn Deceleration Lanes (Table 2-3) are needed under All conditions 2014 Short Course 2

Right Turn Lane Design 1. Storage Length 2. Taper Length 3. Deceleration Length 4. Lane Width Storage Deceleration Length of Turn Lane Taper 2014 Short Course 3

Storage Length, Right Turn Traffic Projections round to tens or more. Queue Length estimated: HCM Software (HCS) SYNCHRO VISSIM Minimum storage length for a single right turn lane is 30 feet per Roadway Design Manual. For trucks, use appropriate vehicle length. Storage 2014 Short Course 4

Right Turn Lane Design Criteria : Storage Or estimated by : Where: L= ( V N )(2)(S) L= Storage length, feet V= Turning volume per hour, vph N= Number of cycles if signalized or 30 if unsignalized 2 = Factor for storage of all vehicles. (1.8 may be acceptable on collector streets) S= queue storage length per vehicle, feet, typically 25 feet for automobiles, adjust per % of Trucks using table to right Storage % of Trucks S (Feet) <5 25 5-9 30 10-14 35 15-19 40 2014 Short Course 5

Right Turn Lane Design Criteria : Taper Length Taper length can be shortened with no detrimental effects, but should not be lengthened. Straight line taper or an equivalent distance set of reverse curves on curbed roadways. Dual lane taper lengths are 100 feet for < 40 mph and 150 feet for higher speeds per RDM, Table 3-4. Speed (MPH) Taper Single Lane Taper Length 30 to 40 50 ft. 45 to 55 100 ft. >= 60 150 ft. 2014 Short Course 6

Right Turn Lane Design Criteria : Deceleration Length Moderate deceleration occurs in the through lane, creating speed differential. Ideal speed differential in through lane is 10 MPH; however, frequently 15 MPH and 20 MPH are acceptable. Values are included in RDM. Deceleration Speed (MPH) Speed Differential 10 MPH 15 MPH 20 MPH 30 160 ft 110 ft 75 ft 35 215 ft 160 ft 110 ft 40 275 ft 215 ft 160 ft 45 345 ft 275 ft 215 ft 50 425 ft 345 ft 275 ft 55 510 ft 425 ft 345 ft Roadway Design Manual, Tables 3-3 and 3-3A 2014 Short Course 7

Right Turn Lane Design Criteria : Deceleration Length AASHTO Green Book (2011) deceleration rates. While moving laterally into turn lane = 5.8 fps 2 When in turn lane = 6.5 fps 2 Emergency braking = 14.8 fps 2 to 11.2 fps 2 Per Stover & Koepke, Transportation & Land Development, ITE, observed deceleration rates for drivers braking to a stop (Fig 5-19, p. 5-41) 85 th percentile deceleration rate = 6.7 fps 2 50 th percentile deceleration rate = 9.2 fps 2 2014 Short Course 8

Turn Lane Design Criteria: Lane Width Speed (mph) Minimum Lane Width (ft)* <= 30 10 35-40 11 >= 45 12 *Roadway Design Manual, Table 3-1 for Urban Streets allows for 9 ft. wide speed change lanes on Local streets with design speed of 30 mph. RDM allows for 10 ft. wide speed change lane on 60 mph Local streets. 2014 Short Course 9

2014 Short Course 1 0 Left Turn Lane Design Criteria: Components 1. Storage - Minimum length 100 feet 2. Taper Same as Right Turn 3. Deceleration Same as Right Turn 4. Width Same as Right Turn Storage Deceleration Length of Turn Lane Taper

Left Turn Lane Design Criteria : Storage Length Macroscopic or Microscopic Analysis: HCM Software (HCS), Synchro, VISSIM 100 feet is minimum for single lane. Storage length calculated by : L= ( V N )(2)(S) Storage Where: L= Storage Length, feet V= Turning Volume per hour, vph N= Number of Cycles if signalized or 30 if Unsignalized 2 = Factor for storage of all vehicles. (1.8 may be acceptable on collector streets) S= queue storage length per vehicle, feet, typically 25 feet for automobiles, adjust per % of Trucks using table to right % of Trucks S (Feet) <5 25 5-9 30 10-14 35 15-19 40 2014 Short Course 11

Obstructions to Providing Desirable Turn Lane Length Drainage Features Culvert Bridge Basin Trees Restricted Right-of-Way Property Line(s) Utilities Electrical Transmission Towers Major Communication Hubs/Ducts Railroad Crossings Desirable Turn Length Adjacent Driveway or Intersection 2014 Short Course 12

Obstructions to Providing Desirable Turn Lane Length Extreme Peak Period Turning Volume Comment: Under congested operation vehicle speeds are typically lower & queued vehicles can extend beyond the storage area and into the deceleration portion of the turn lane. While not desirable, it is relatively common in urban areas. Desirable Turn Length 2014 Short Course 13

Key Point As the difference in vehicle speeds increase, crash rate increases. What does that mean for Engineers & Designers? - Adequate left-turn length is important but ANY length of turn lane is better than no turn lane. 2014 Short Course 14

Creative Turn Lane Designs Sweeping Turns Not pedestrian friendly due to high speed turn. Fits the current context of this location and the frontage road. Loop 1604 SBFR 2014 Short Course 15

Turn Lane Design Trade Off Right turn lane extends the length of the adjacent property with existing driveways. Vehicle on driveway may assume right-turning vehicle is turning at driveway and not at street. Current decisions seem to be personal experience/opinion. Options: 1) Use multiple short turn lanes. 2) Extend turn lane across multiple driveway. 2014 Short Course 16

Left Turn Lane Design Consideration Sight Distance Offset Left Turn Lanes Negative Offset Positive Offset 2014 Short Course 17

Offset Design for Sight Obstruction Problem: Westbound (down) lanes approximately 4 feet higher than the eastbound lanes. Sight obstruction due to geometrics and terrain versus opposing vehicle. Crest vertical curve located east of driveway, compounding left-turn ingress sight distance. Solution Offset left-turn lane constructed, plus it allows for grade of left-turning traffic to match grade of westbound lanes, improving sight distance. 2014 Short Course 18

Key Point As the difference in vehicle speeds increase, so does the expected crash rate. What does that mean? - Adequate left-turn length is important but ANY length of turn lane is better than no turn lane. 2014 Short Course 19

Questions Gilmer D. Gaston, P.E., PTOE 210.375.9000 210.316.0189 ggaston@pape-dawson.com San Antonio Austin Houston Fort Worth Dallas

Total Length = Storage + Deceleration Speed (mph) Minimum Left Turn Lane (ft) Minimum Right Turn Lane (ft) 40 375 305 45 445 375 50 525 455 2014 Short Course 21