Part no. 070.100.650.009 Roof spoler
Contents I Important safety nformaton...3 II Preparaton...5 III Installaton...6 1 Preparng the vehcle...6 2 Fttng the...6 3 Fnal nspecton...6 TECHART Verson 01 Page 2 of 7
I Important safety nformaton All of the necessary work must be performed by qualfed persons wth an approprate level of expertse. Vehcle lfts wth an nsuffcent lftng capacty can collapse under the weght of the vehcle and crush any persons standng underneath. Compare the weght of the vehcle wth the lftng capacty of your vehcle lft. The weght of the vehcle must not exceed the lftng capacty of your vehcle lft. The weght of the vehcle can be found n the vehcle operatng manual. Rsk of njury from electrc current. Swtch off the gnton and dsconnect the battery when workng on the vehcle electrcal/electroncs systems. Rsk of fre and exploson from gnton of wndsheld cleanng agents/antfreeze and ther vapors. Rsk of posonng from ngestng wndsheld cleanng agents/antfreeze and breathng n ther vapors. Rsk of njury due to rrtaton caused by wndsheld cleanng agents/antfreeze comng nto contact wth eyes, skn and other parts of the body. Wear protectve clothng and safety glasses. Avod naked flames, fre and sources of gnton. Avod contact wth eyes, skn and other parts of the body. Do not eat, drnk or smoke when handlng wndsheld cleanng agents/antfreeze. Do not breathe n vapors and ensure adequate ventlaton. Keep wndsheld cleanng agents/antfreeze only store them n sealable orgnal contaners. TECHART Verson 01 Page 3 of 7
Rsk of njury from hands and arms beng crushed, cut or lacerated when workng wth sharp-edged and bulky objects. Wear protectve clothng and protectve gloves. Keep lmbs out of narrow and naccessble areas of the vehcle and/or avod dangerous stuatons by usng specal tools and sutable ads. Rsk of njury to back, muscles, jonts, tendons and lgaments from lftng and carryng heavy and/or bulky objects. Lft and transport heavy and/or bulky objects wth the help of other people and/or wth sutable ads. Before startng the assembly procedure, carefully read the assembly nstructons n full and pay attenton to the safety nformaton and sequence of the ndvdual operaton steps. All body parts must be prepared and panted n accordance wth the attached pantng gude. TECHART Verson 01 Page 4 of 7
II Preparaton Number of people requred At least two people are requred to nstall ths product. Help and support If you have any techncal queres, please contact us mmedately: support@techart.de Check the TECHART parts kt for completeness Item Quantty Part number Part desgnaton 1 1 070.100.650.009 Roof spoler Consstng of: 1 070.100.650.100 Roof spoler 1 070.100.650.103 Roof spoler adhesve label 1 00091089010031 Klebt + Dchtet (adhesve sealant) black, 70ml tube Use the table to check whether all of the requred parts are present. Please contact us mmedately f any parts are mssng: support@techart.de Once parts have been removed from ther orgnal packagng, ensure that they are properly handled and stored. TECHART Verson 01 Page 5 of 7
III Installaton 1 Preparng the vehcle Before startng work, check that the vehcle s free from defects. Use the PIWIS system tester to read out all the fault memores of the ndvdual vehcle components and frst rectfy any faults dsplayed. 2 Fttng the The bondng surfaces on the and the rear wndow must be dry and free of dust. Use cleanng agent to thoroughly degrease the bondng surfaces on the and the rear wndow. Do not touch the surfaces after they have been cleaned. 1 Apply a thn even coatng of PU adhesve to the bondng surfaces on the 070.100.650.100. 2 Ft the. Press the on frmly n the bondng area. Ensure an accurate ft and remove any escapng adhesve wth cleanng agent. 3 Fx the n place wth adhesve tape so that t has frm contact wth the surface at all ponts. Allow to dry for at least 12 hours. 3 Fnal nspecton 1 Perform a general functon check on the vehcle. Read out all of the fault memores of the ndvdual vehcle components usng the PIWIS Porsche system tester, erase any fault messages dsplayed and/or rectfy faults. TECHART Verson 01 Page 6 of 7
TECHART AUTOMOBILDESIGN GMBH RÖNTGENSTRASSE 47 D-71229 LEONBERG / GERMANY TEL +49 (0) 7152 / 9339-0 FAX +49 (0) 7152 / 9339-33 nfo@techart.de www.techart.de E&O excepted. Subject to change at any tme wthout pror notce. Copyrght 2008 by TECHART Automobldesgn GmbH Verson 01/2009 Artkel-Nr./Part No. 070.100.650.099 TECHART Verson 01 Page 7 of 7