PROPORTIONL PREISION PRESSURE REGULTOR REGTRONI SERIES Proportional pressure regulators series REGTRONI have the job of precisely regulating the pressure in a system, the variables depending on the input command. The pressure value and a series of information and diagnostics are visible at all times on the graphic display. The user-display interface, LEDs and buttons are all on one side. The programming and reading software is comprehensive, simple and intuitive. Pressure control takes place in a closed-loop with an electronic precision pressure sensor that measures the downstream pressure, a control system that compares it with the desired pressure, and two mini solenoid valves that adjust the pressure to reach the target value. PROPORTIONL PREISION PRESSURE REGULTOR REGTRONI SERIES TEHNIL DT Threaded ports Fluid MIN inlet pressure bar MX inlet pressure bar Temperature range Pressure regulation range bar Flow rate at. bar P. bar Nl/min Flow rate at. bar P bar Nl/min Exhaust flow rate at. bar with. bar overpressure Nl/min Exhaust flow rate at. bar with. bar overpressure Nl/min Weight Kg lass of protection Power supply Input signal (input impedence) Output signal Linearity Hysteresis Repeatability Sensitivity/Dead-band Output pressure display nalog output accuracy Temperature characteristics Response time with P = bar from to bar from to bar Installation position Note Voltage urrent Serial ports Manual nalog Digital ccuracy Unit of measurement Minimum resolution s s REGTRONI REGTRONI REGTRONI REGTRONI NEW DEL / / / / / / / Filtered, unlubricated air. The air must be filtered at least µm Regulation pressure + bar - to. to (settable full scale and minimum pressure) 9.. - -..... IP Vcc +% -% I max m to Vcc, to Vcc (approx. KΩ) to m (approx. KΩ) RS Keypad to Vcc ( V=bar) - m max PNP open collector output:: max V m NPN open collector output: max V m ±.% (Full scale) ±.% (Full scale) ±.% (Full scale) setting range to mbar ±,% (Full scale) bar, Mpa, psi. bar -. MPa -. psi ±,% (Full scale) max mbar / volume cc volume cc volume cc volume cc........ in any position The features shown refer to the static condition only. With air consumption on the output side, the pressure may vary. -
LIQUID RYSTL GRPHI DISPLY PROGRMMLE ND FLEXILE Setting options: LNGUGE UNIT OF MESUREMENT TYPE OF INPUT TYPE OF DIGITL OUTPUT DED-ND s well as the pressure, it displays complete intuitive messages covering several lines. FULL SLE MINIMUM PRESSURE PREISION M x ONNETOR Linearity ±, % (full scale) Hysteresis ±, % (full scale) Repeatability Sensitivity ±, % (full scale) range to mbar ONFIGURTION OF THE MX -PIN ONNETOR = TX (RS) (White) = RX (RS) (rown) = set - V / - V / - m (Green) = digital out - V NPN (Yellow) = analog out - V (Grey) = digital out - V PNP (Pink) = V (GND) (lue) = power supply +V (Red) -pin connector - standard - available from the trade FUNTION DIGRM INPUT SIGNL INLET SOLENOID VLVE DISPLY ONTROL IRUIT OUTPUT SIGNL OUTLET SOLENOID VLVE PROPORTIONL PREISION PRESSURE REGULTOR REGTRONI SERIES PRESSURE SENSOR IN OUT Regulator connectorviewed from above -
REGTRONI / ; / OMPONENTS REGTRONI / ; / a RTRIDGES: nickel-plated brass b RING: vulcanized NR c ROD: steel d ODIES: painted aluminium e PRESSURE SENSOR f SOLENOID VLVE: mm series PLT- g SHELL: technopolymer h ONNETOR M pin i ELETRONI ORDS j ONTROL DIPHRGM: anti-oil rubber k SPRING: stainless steel l POPPET: nickel-plated brass FLOW HRTS / ON EXHUST ON REGULTION / ON EXHUST ON REGULTION 9 D 9 D - - - - - - - - - - - - - - - - - - =. bar = bar =. bar D = bar -
INSTLLTION IN OUT IN OUT IN OUT On the wall with M hex screws On the base with legs code 9 On the wall with legs code 9 REGTRONI / ; / DIMENSIONS ND ORDERING ODES REGTRONI / REGTRONI / IN OUT -
REGTRONI OMPONENTS REGTRONI NEW DEL a REGULTOR ODY: aluminium b LOWER P: aluminium c UPPER PLTE: aluminium d SPER: aluminium e GSKET: NR f PISTON ROD: aluminium g P FOR PLIN GSKET: OT brass h PLIN GSKET: NR i ROD: OT brass j VLVE: OT brass k VLVE SPRING: steel l GSKETS: NR m ELETRONI ORDS n ONNETOR M PIN o PRESSURE SENSOR p SOLENOID VLVE: mm series PLT- q SHELL: tecnopolymer FLOW HRTS DIMENSIONS ND ORDERING ODES ON EXHUST ON REGULTION - - 9 =. bar = bar =. bar Pm = bar REGTRONI / REGTRONI -
REGTRONI OMPONENTS a ODY: tecnopolymer b END PLTE: zamak c STEM: OT brass d UPPER UP: aluminium e PISTON: OT brass f UP: aluminium g PRESSURE SENSOR h SOLENOID VLVE: mm series PLT- i SHELL: tecnopolymer j ONNETOR M PIN k ELETRONI ORDS l GSKET: NR m VLVE WITH NR VULNIZED GSKET n VLVE SPRING: stainless steel o LOWER UP: tecnopolymer REGTRONI FLOW HRTS DIMENSIONS ND ORDERING ODES ON EXHUST ON REGULTION - =. bar = bar =. bar Pm = bar REGTRONI without end plates REGTRONI / REGTRONI / REGTRONI G / / -
REGTRONI OMPONENTS REGTRONI a ODY: luminium b END PLTE: luminium c THREDED USH, XIL DJUSTMENT: OT brass d RETINING RING: OT brass e ROLLING DIPHRGM f RSS PLUG: OT brass g VLVE SPRING: Stainless steel h STEM: OT brass with air relief hole i VLVE WITH NR VULNIZED GSKET j GSKETS: NR k ONNETOR M PIN l SHELL: technopolymer m SOLENOID VLVE: mm series PLT- n PRESSURE SENSOR o ELETRONI ORDS FLOW HRTS REGTRONI to / ON EXHUST ON REGULTION = bar = bar = bar Pm = bar - - - - 9 9 -
REGTRONI ON EXHUST ON REGULTION = bar = bar = bar Pm = bar - - - - 9 9 DIMENSIONS REGTRONI Threaded port G / / to to D E. F H I. L M hole M. N. R (exhaust) / REGTRONI ORDERING ODES REGTRONI without edn plates REGTRONI REGTRONI / REGTRONI / REGTRONI NOTES -
ESSORIES REGTRONI Mx PRE-WIRED -PIN FEMLE STRIGHT ONNETOR W9 MX pre-wired -PIN strainght connector, cable L = m Mx PRE-WIRED -PIN FEMLE 9 ONNETOR W9 MX pre-wired -PIN 9 connector, cable L= m - White - rown - Green - Yellow - Grey - Pink - lue - Red - White - rown - Green - Yellow - Grey - Pink - lue - Red FIXING RKET KIT FOR REGTRONI / E / 9 Fixing bracket kit N.. supplied complete with four MX screws ONNETOR KIT FOR SKILLIR ODE 9 onnector kit 9 onnector kit ESSORIES REGTRONI INPUT/OUTPUT END PLTE KIT FOR SKILLIR 9 IN/OUT end plate kit / 99 IN/OUT end plate kit / 9 IN/OUT end plate kit 9 IN/OUT end plate kit 9 IN/OUT end plate kit / 9 IN/OUT end plate kit / 9 IN/OUT end plate kit NOTES -