General info 29 x29 x13 1 operator required 4 players max at one time Max weight per person 225lbs Minimum height 44 maximum height 80 2 x 1.5 hp blower WRECKING BALL Setup Unroll the inflatable onto a flat ground area, install at least 5 ground stakes around the perimeter, and loosely tie the tethers to the ground stakes. Connect blower to the unit and turn on. As the unit inflates close the zipper at the backside of inflatable. Secure the tethers after the unit if fully inflated. Perform a final safety check around the unit prior to letting passengers on. Warning: Prior to setting the stakes into the ground, check for sprinkler systems, water or electricity lines. Set up stakes 6-8 ft from the inflatable in case anyone falls over the edge. Attaching the ball Attach the rope to the underside of the middle of the inflatable. The rope will then attach to the ball using a D-ring. How to play Enter the bounce house through the opening in the front. Each child has their own stand. Each child stands on a platform and swings the ball trying to knock one another off. At an event with a line, we recommend 1 ½ minutes to 2 minutes play time, than that group out next group in. NO STANDING ON THE FRONT ENTRANCE. NO HANGING FROM THE BALL. NO FLIPS. NO BACK FLIPS. Take down Begin by disconnecting power to the blower; unzip the backside of the bounce house and detach ball. After unit is deflated, fold the unit into 4ths. Roll from the entrance to the backside with zipper. Leaving the air tubes open helps let the air out while rolling. Mother Nature In the event of severe weather (lightning, 20+ mph winds, rain, etc) safely exit the inflatable unit, disconnect power, and go indoors for your safety. Once the weather has passed, you may continue using the inflatable after examining the unit for safety. When the inflatable is wet, please inflate and dry off. Warning: If the unit has become wet you must notify Bounce Around Inflatables as this can damage the unit if it is not dried correctly. In the example that you do not notify us, we may charge you the full amount to fix the unit. Basics All players should remove shoes, jewelry, and any hard or sharp items from their pockets that could cause injury. To avoid neck and back injuries, FLIPS ARE NOT ALLOWED. I the lessee have read and understood the rules for this inflatable. The lessee has agreed to follow the rules that are presented by Bounce Around Inflatables, LLC. Lessee: Date:
5500 S. Wexford Ct. Sioux Falls, SD Phone: 605-310-9529 Email: RyanHulsebus@gmail.com SET UP The Bounce Around Inflatable may weigh over 300 lbs. Caution should be exercised when lifting and handling the equipment. Use a dolly to move the equipment. Please pay attention to how it was rolled up. We ask that the inflatable comes rolled back up the same way you received it. Thank you, Bounce Around Inflatables, LLC. DO NOT set up when windy and or it rains. MUST use a tarp when placing on tar or cemented areas. No tarp necessary on grass. Select a level area that is a safe distance from water, walls and other obstructions. Make certain that there are no overhead utility wires and ground obstacles such as protruding sprinklers or underground pipes of any kind before laying the protective tarp on the selected area. Place the Bounce Around Inflatable in the middle of the tarp and unroll the unit after removing the straps.
Connect either tube snugly (choose the one closest to the electricity source) to the blower using the strap attached to the tube. Make sure that all intake openings of the blower are free from any obstructions. 8. Twist the vent (the other tube) several times, fold it over and secure snugly with the attached strap. Close any extra zipper vents that may be open on the inflatable for quick deflation. NOTE: Not all inflatables have more than one tube. Only applicable if there is more than 2 air tubes.
9. Drive an anchor at least 3 feet from the inflatable to the ground at a 45 degree angle with the head pointing away from the Inflatable unit. Secure the unit at all times to the corresponding number of anchors. Use the straps to attach the anchors to all the double-loops as provided in specific areas on the base of the Inflatable unit. Large units with high profiles (Giant Slides, etc) have additional tie down loops that are located at higher points. Each of these additional locations should also be attached to the anchor at a 45 angle. 10. Plug the blower into the closest properly grounded (GFCI) 110v outlet only after you carefully read the blower manufacturer's safety instructions. Turn the switch on and wait (approximately 2 minutes) until the Bounce Around Inflatable is fully inflated and the equipment and all parts have been examined for potentially unsafe conditions before letting children in the Bounce Around Inflatable. As it inflates there may be zippers that need to be closed. If the inflatable feels soft, a zipper or end must be closed off. 11.This unit requires continuous air pressure. Do not turn the blower off while children are in the Bounce Around Inflatable. DEFLATION PROCEDURES 1. Make sure there are no children inside or around the Bounce Around Inflatable unit before you turn the switch off and unplug the blower. 2. Disconnect the air tube from the blower and untie the second air tube. Unzip the quick release air chambers usually located beside the air tubes. Let both air tubes lie parallel to each other so the air can escape freely
3. As the Bounce Around Inflatable deflates, arrange the columns to fall on top of the base making sure that the deflated unit is evenly spread out. IMPORTANT When rolling inflatable, make sure all colored vinals are inside of roll. You should only be able to see the bottom of inflatable once completely rolled. This will protect inflatable during transport and keep the lessee from receiving damage fee s When rolling, be sure to start the roll as tight as possible, as this will create easy mobility and easier maneuvering. 4. Fold the outside edges in to make the unit square. Fold in the entrance ramp.
5. Fold in the corners to make the inflatable square. Standing in front of the Bounce Around unit (Entrance), fold the left side and the right side so that they meet in the middle and then fold one side over the other. 6. ALWAYS roll the Bounce Around unit towards the air tubes and then tuck the air tubes into the roll. (Normally rolling it from front to back) 7. Secure the roll with each strap 8. Dolly the Bounce Around tied into a slip knot. unit into a dry area for storage.