: STAPA DL REFLEXAL 212/80 Aluminium Paste

Transcription

1 SECTION 1: Identification of the substance/mixture and of the company/undertaking 1.1 Product identifier Trade name : 1.2 Relevant identified uses of the substance or mixture and uses advised against This information is not available. 1.3 Details of the supplier of the safety data sheet Company : ECKART GmbH Guentersthal Hartenstein Telephone : Telefax : address : msds.eckart@altana.com Responsible/issuing person 1.4 Emergency telephone number GBK Gefahrgut Büro GmbH, Ingelheim, Germany: From outside US: : (001) (First call in English, response in your language is possible) US & Canada (toll free) : SECTION 2: Hazards identification 2.1 Classification of the substance or mixture Classification (REGULATION (EC) No 1272/2008) Not a dangerous substance according to GHS. Classification (67/548/EEC, 1999/45/EC) Not a hazardous substance or mixture. 2.2 Label elements Labelling (REGULATION (EC) No 1272/2008) Not a dangerous substance or mixture according to the Globally Harmonised System (GHS). 2.3 Other hazards No information available. Page 1 / 13

2 SECTION 3: Composition/information on ingredients 3.2 Mixtures Hazardous components Chemical Name CAS-No. EC-No. Registration number aluminium Classification (67/548/EEC) Classification (REGULATION (EC) No 1272/2008) Concentration [%] F; R11 Flam. Sol. 1; H228 >= 50 - <= 100 For the full text of the R-phrases mentioned in this Section, see Section 16. For the full text of the H-Statements mentioned in this Section, see Section 16. SECTION 4: First aid measures 4.1 Description of first aid measures General advice : No hazards which require special first aid measures. Move the victim to fresh air. Do not leave the victim unattended. If inhaled In case of skin contact In case of eye contact : If unconscious place in recovery position and seek medical advice. If symptoms persist, call a physician. : Wash off immediately with soap and plenty of water. : Remove contact lenses. If eye irritation persists, consult a specialist. Immediately flush eye(s) with plenty of water. If swallowed : Keep respiratory tract clear. Do not give milk or alcoholic beverages. Never give anything by mouth to an unconscious person. If symptoms persist, call a physician. 4.2 Most important symptoms and effects, both acute and delayed Symptoms : No information available. Page 2 / 13

3 Risks : No information available. 4.3 Indication of any immediate medical attention and special treatment needed Treatment : No information available. SECTION 5: Firefighting measures 5.1 Extinguishing media Suitable extinguishing media Unsuitable extinguishing media : Dry sand, Special powder against metal fire : ABC powder, Carbon dioxide (CO2), Water, Foam 5.2 Special hazards arising from the substance or mixture This information is not available. 5.3 Advice for firefighters Special protective equipment for firefighters : Use personal protective equipment. Wear self contained breathing apparatus for fire fighting if necessary. Further information : Use a water spray to cool fully closed containers. Collect contaminated fire extinguishing water separately. This must not be discharged into drains. Fire residues and contaminated fire extinguishing water must be disposed of in accordance with local regulations. Standard procedure for chemical fires. Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. SECTION 6: Accidental release measures 6.1 Personal precautions, protective equipment and emergency procedures Personal precautions : Avoid dust formation. Evacuate personnel to safe areas. Use personal protective equipment. 6.2 Environmental precautions Page 3 / 13

4 This information is not available. 6.3 Methods and materials for containment and cleaning up Methods for cleaning up 6.4 Reference to other sections For personal protection see section 8. : Pick up and arrange disposal without creating dust. Sweep up and shovel. Do not flush with water. Keep in suitable, closed containers for disposal. Use mechanical handling equipment. Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust). SECTION 7: Handling and storage 7.1 Precautions for safe handling Advice on safe handling Advice on protection against fire and explosion Hygiene measures : For personal protection see section 8. Smoking, eating and drinking should be prohibited in the application area. : Normal measures for preventive fire protection. : General industrial hygiene practice. 7.2 Conditions for safe storage, including any incompatibilities Requirements for storage areas and containers : Electrical installations / working materials must comply with the technological safety standards. Earthing of containers and apparatuses is essential. Reaction with water liberates extremely flammable gas (hydrogen) Take measures to prevent the build up of electrostatic charge. Use explosion-proof equipment. Store in original container. Keep containers tightly closed in a cool, well-ventilated place. Keep away from sources of ignition - No smoking. Keep container closed when not in use. Further information on storage conditions Advice on common storage Page 4 / 13 : Protect from humidity and water. : Do not store near acids. Do not store together with oxidizing and self-igniting products. Keep away from oxidising agents and strongly acid or alkaline materials. Never allow product to get in contact with water during storage. Keep away from

5 oxidising agents, strongly alkaline and strongly acid materials in order to avoid exothermic reactions. Other data : No decomposition if stored and applied as directed. 7.3 Specific end use(s) This information is not available. SECTION 8: Exposure controls/personal protection 8.1 Control parameters Components CAS-No. Value type (Form of exposure) Control parameters Update Basis aluminium TWA (Inhalable) 10 mg/m GB EH40 Further information aluminium TWA (Respirable) Further information The COSHH definition of a substance hazardous to health includes dust of any kind when present at a concentration in air equal to or greater than 10 mg.m-3 8-hour TWA of inhalable dust or 4 mg.m-3 8-hour TWA of respirable dust. This means that any dust will be subject to COSHH if people are exposed above these levels. Some dusts have been assigned specific WELs and exposure to these must comply with the appropriate limit.where no specific short-term exposure limit is listed, a figure three times the long-term exposure should be used 4 mg/m GB EH40 The COSHH definition of a substance hazardous to health includes dust of any kind when present at a concentration in air equal to or greater than 10 mg.m-3 8-hour TWA of inhalable dust or 4 mg.m-3 8-hour TWA of respirable dust. This means that any dust will be subject to COSHH if people are exposed above these levels. Some dusts have been assigned specific WELs and exposure to these must comply with the appropriate limit.where no specific short-term exposure limit is listed, a figure three times the long-term exposure should be used aluminium TWA (Inhalable) 10 mg/m GB EH40 Page 5 / 13 Further information For the purposes of these limits, respirable dust and inhalable dust are those fractions of airborne dust which will be collected when sampling is undertaken in accordance with the methods described in MDHS14/3 General methods for sampling and gravimetric analysis of respirable and inhalable dustthe COSHH

6 aluminium TWA (Respirable) Further information definition of a substance hazardous to health includes dust of any kind when present at a concentration in air equal to or greater than 10 mg.m-3 8-hour TWA of inhalable dust or 4 mg.m-3 8-hour TWA of respirable dust. This means that any dust will be subject to COSHH if people are exposed above these levels. Some dusts have been assigned specific WELs and exposure to these must comply with the appropriate limit.most industrial dusts contain particles of a wide range of sizes. The behaviour, deposition and fate of any particular particle after entry into the human respiratory system and the body response that it elicits, depend on the nature and size of the particle. HSE distinguishes two size fractions for limit-setting purposes termed 'inhalable' and 'respirable'.inhalable dust approximates to the fraction of airborne material that enters the nose and mouth during breathing and is therefore available for deposition in the respiratory tract. Respirable dust approximates to the fraction that penetrates to the gas exchange region of the lung. Fuller definitions and explanatory material are given in MDHS14/3.Where dusts contain components that have their own assigned WEL, all the relevant limits should be complied with.where no specific short-term exposure limit is listed, a figure three times the long-term exposure should be used 4 mg/m GB EH40 For the purposes of these limits, respirable dust and inhalable dust are those fractions of airborne dust which will be collected when sampling is undertaken in accordance with the methods described in MDHS14/3 General methods for sampling and gravimetric analysis of respirable and inhalable dustthe COSHH definition of a substance hazardous to health includes dust of any kind when present at a concentration in air equal to or greater than 10 mg.m-3 8-hour TWA of inhalable dust or 4 mg.m-3 8-hour TWA of respirable dust. This means that any dust will be subject to COSHH if people are exposed above these levels. Some dusts have been assigned specific WELs and exposure to these must comply with the appropriate limit.most industrial dusts contain particles of a wide range of sizes. The behaviour, deposition and fate of any particular particle after entry into the human respiratory system and the body response that it elicits, depend on the nature and size of the particle. HSE distinguishes two size fractions for limit-setting purposes termed 'inhalable' and 'respirable'.inhalable dust approximates to the fraction of airborne material that enters the nose and mouth during breathing and is therefore available for deposition in the respiratory tract. Respirable dust approximates to the fraction that penetrates to the gas exchange region of the lung. Fuller definitions and explanatory material are given in MDHS14/3.Where dusts contain components that have their own assigned WEL, all the relevant limits should be complied Page 6 / 13

7 with.where no specific short-term exposure limit is listed, a figure three times the long-term exposure should be used 8.2 Exposure controls Personal protective equipment Eye protection : Safety glasses : Goggles Hand protection Material : Solvent-resistant gloves (butyl-rubber) Remarks : Take note of the information given by the producer concerning permeability and break through times, and of special workplace conditions (mechanical strain, duration of contact). The exact break through time can be obtained from the protective glove producer and this has to be observed. Please observe the instructions regarding permeability and breakthrough time which are provided by the supplier of the gloves. Also take into consideration the specific local conditions under which the product is used, such as the danger of cuts, abrasion, and the contact time. Recommended preventive skin protection Skin should be washed after contact. The suitability for a specific workplace should be discussed with the producers of the protective gloves. Skin and body protection : Protective suit Respiratory protection : Use suitable breathing protection if workplace concentration requires. Environmental exposure controls Water : The product should not be allowed to enter drains, water courses or the soil. Page 7 / 13

8 SECTION 9: Physical and chemical properties 9.1 Information on basic physical and chemical properties Appearance : Pasty solid Colour : silver Odour : characteristic ph Freezing point Boiling point/boiling range Flash point : > 300 C Bulk density Flammability (solid, gas) : The product is not flammable. Auto-flammability Upper explosion limit Lower explosion limit Vapour pressure Density Water solubility Solubility in other solvents Partition coefficient: n-octanol/water Auto-ignition temperature Thermal decomposition Viscosity, dynamic Viscosity, kinematic Flow time 9.2 Other information Page 8 / 13

9 SECTION 10: Stability and reactivity 10.1 Reactivity No decomposition if stored and applied as directed Chemical stability No decomposition if stored and applied as directed Possibility of hazardous reactions Hazardous reactions : Stable under recommended storage conditions Conditions to avoid Conditions to avoid Do not allow evapouration to dryness Incompatible materials Materials to avoid 10.6 Hazardous decomposition products Hazardous decomposition products Other information SECTION 11: Toxicological information 11.1 Information on toxicological effects Acute toxicity Components: : Acute inhalation toxicity : LC50 rat: > 5 mg/l Exposure time: 4 h Test atmosphere: dust/mist Page 9 / 13

10 Skin corrosion/irritation Serious eye damage/eye irritation Respiratory or skin sensitisation Carcinogenicity Toxicity to reproduction/fertility Reprod.Tox./Development/Teratogenicity STOT - single exposure STOT - repeated exposure Aspiration toxicity Further information Product Page 10 / 13

11 SECTION 12: Ecological information 12.1 Toxicity 12.2 Persistence and degradability 12.3 Bioaccumulative potential 12.4 Mobility in soil 12.5 Results of PBT and vpvb assessment 12.6 Other adverse effects Product: Additional ecological information SECTION 13: Disposal considerations European Waste Catalogue : non-ferrous metal dust and particles 13.1 Waste treatment methods Contaminated packaging : Empty containers should be taken to an approved waste handling site for recycling or disposal. Page 11 / 13

12 SECTION 14: Transport information 14.1 UN number 14.2 Proper shipping name 14.3 Transport hazard class 14.4 Packing group 14.5 Environmental hazards 14.6 Special precautions for user Not classified as dangerous in the meaning of transport regulations Transport in bulk according to Annex II of MARPOL 73/78 and the IBC Code SECTION 15: Regulatory information 15.1 Safety, health and environmental regulations/legislation specific for the substance or mixture Water contaminating class (Germany) : nwg not water endangering 15.2 Chemical Safety Assessment SECTION 16: Other information Full text of R-Phrases R11 Highly flammable. Full text of H-Statements H228 Flammable solid. Page 12 / 13

13 The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text. Page 13 / 13