Material Safety Data Sheet

Transcription

1 Material Safety Data Sheet Revision Number: Issue date: 01/28/ PRODUCT AND COMPANY IDENTIFICATION Product name: LOCTITE AA H3000 B known as Kit PART B Product use: Adhesive Item number: 83001_AB0300 Region: Canada Company address: Contact information: Henkel Canada Corporation 2515 Meadowpine Boulevard Mississauga, Ontario L5N 6C3 Telephone: MEDICAL EMERGENCY Phone: Poison Control Center (toll free) or TRANSPORT EMERGENCY Phone: CHEMTREC (toll free) or Internet: 2. HAZARDS IDENTIFICATION EMERGENCY OVERVIEW Physical state: Liquid, Paste WHMIS hazard class: B.2, D.2.A, D.2.B Color: Opaque, Tan Odor: Strong WARNING: Relevant routes of exposure: FLAMMABLE LIQUID AND VAPOR. MAY CAUSE ALLERGIC SKIN REACTION. MAY CAUSE EYE, SKIN AND RESPIRATORY TRACT IRRITATION. MAY BE HARMFUL IF SWALLOWED. Skin, Inhalation, Eyes, Ingestion Potential Health Effects Inhalation: Skin contact: Eye contact: Ingestion: Existing conditions aggravated by exposure: Vapors may cause headaches, nausea, dizziness and respiratory tract irritation. May cause allergic skin reaction. May cause skin irritation. This product may cause irritation to the eyes. May cause gastrointestinal tract irritation if swallowed. May be harmful if swallowed. Eye, skin, and respiratory disorders. Liver disorders. Kidney disorders. See Section 11 for additional toxicological information. 3. COMPOSITION / INFORMATION ON INGREDIENTS Hazardous components CAS NUMBER % Methyl methacrylate Aldehyde-amine condensate Toluene FIRST AID MEASURES Inhalation: Move to fresh air. If breathing is difficult, give oxygen. If not breathing, give artificial respiration. If symptoms develop and persist, get medical attention. Page 1 of 5

2 Skin contact: Eye contact: Ingestion: Immediately flush skin with plenty of water (using soap, if available). Remove contaminated clothing and footwear. If symptoms develop and persist, get medical attention. Wash clothing before reuse. Thoroughly clean shoes before reuse. Flush with copious amounts of water, preferably, lukewarm water for at least 15 minutes, holding eyelids open all the time. Get medical attention. DO NOT induce vomiting unless directed to do so by medical personnel. Never give anything by mouth to an unconscious person. Get medical attention. 5. FIRE FIGHTING MEASURES Flash point: Autoignition temperature: Flammable/Explosive limits - lower: Flammable/Explosive limits - upper: Extinguishing media: Special firefighting procedures: Unusual fire or explosion hazards: Hazardous combustion products: Sensitivity to Mechanical Impact: Sensitivity to static discharge: 14 C (57.2 F) Setaflash Closed Cup Foam, dry chemical or carbon dioxide. Wear self-contained breathing apparatus and full protective clothing, such as turn-out gear. Vapors may accumulate in low or confined areas, travel considerable distance to source of ignition, and flash back. Closed containers may rupture (due to build up of pressure) when exposed to extreme heat. Oxides of carbon. Oxides of nitrogen. Acrylic monomers. Cyanides. Toxic fumes. Irritating vapors. 6. ACCIDENTAL RELEASE MEASURES Use personal protection recommended in Section 8, isolate the hazard area and deny entry to unnecessary and unprotected personnel. Environmental precautions: Clean-up methods: Do not allow product to enter sewer or waterways. Remove all sources of ignition. Ensure adequate ventilation. Wear appropriate personal protective equipment. Refer to Section 8 "Exposure Controls / Personal Protection" prior to clean up. Soak up with inert absorbent material (e.g. sand, silica gel, acid binder, universal binder, sawdust). Scrape up spilled material and place in a closed container for disposal. 7. HANDLING AND STORAGE Handling: Prevent contact with eyes, skin and clothing. Do not breathe vapor and mist. Wash thoroughly after handling. Do not taste or swallow. During use and until all vapors are gone: Keep area ventilated - do not smoke; extinguish all flames, pilot lights, and heaters; turn off stoves, electrical tools and appliances, and any other sources of ignition. Make sure containers are properly grounded before use or transfer of material. Keep container closed. Page 2 of 5

3 Storage: For safe storage, store at or below 32 C (89.6 F) Keep container tightly closed and in a cool, well-ventilated place away from incompatible materials. Keep away from heat, spark and flame. Protect from direct sunlight. Maintain head space in storage containers to support oxygen requirements of the inhibitor(s). For information on product shelf life contact Henkel Canada Customer Service at EXPOSURE CONTROLS / PERSONAL PROTECTION Employers should complete an assessment of all workplaces to determine the need for, and selection of, proper exposure controls and protective equipment for each task performed. Hazardous components ACGIH TLV OSHA PEL AIHA WEEL OTHER Methyl methacrylate 50 ppm TWA 100 ppm STEL (Sensitizer.) 100 ppm (410 mg/m3) PEL 50 ppm Aldehyde-amine condensate 200 ppm TWA 300 ppm Ceiling Toluene 20 ppm TWA 500 ppm MAX. CONC 10 minutes Engineering controls: Respiratory protection: Eye/face protection: Skin protection: Provide adequate local exhaust ventilation to maintain worker exposure below exposure limits. Use NIOSH approved respirator if there is potential to exceed exposure limit(s). Safety goggles or safety glasses with side shields. Full face protection should be used if the potential for splashing or spraying of product exists. Use chemical resistant, impermeable clothing including gloves and either an apron or body suit to prevent skin contact. Neoprene, Butyl-rubber, or nitrilerubber gloves. 9. PHYSICAL AND CHEMICAL PROPERTIES Physical state: Liquid, Paste Color: Opaque, Tan Odor: Strong Odor threshold: ph: Vapor pressure: Boiling point/range: 100 C (212 F) (1,013 hpa) Melting point/ range: Specific gravity: 1.03 Vapor density: > 1 Flash point: 14 C (57.2 F) Setaflash Closed Cup Flammable/Explosive limits - lower: Flammable/Explosive limits - upper: Autoignition temperature: Evaporation rate: Faster than ether., (Ether = 1) Solubility in water: Slight Partition coefficient (n-octanol/water): VOC content: 1.11 %; 11.7 g/l Estimated Page 3 of 5

4 10. STABILITY AND REACTIVITY Stability: Hazardous reactions: Hazardous decomposition products: Incompatible materials: Conditions to avoid: Stable under normal conditions of storage and use. Polymerization may occur at elevated temperatures or upon depletion of inhibitor. Oxides of carbon. Oxides of nitrogen. Acrylic monomers. Cyanides. Toxic fumes. Irritating vapors. Oxidizing agents. Reducing agents. Acids. Bases. Keep away from heat, ignition sources and incompatible materials. Protect from direct sunlight. Loss of polymerization inhibitor. Loss of dissolved air. Do not mix in batches greater than 100 grams (0.22 pounds) unless you plan to use immediately. 11. TOXICOLOGICAL INFORMATION Toxicologically synergistic products: Refer to the following for Irritancy of Product, Sensitization to Product, Carcinogenicity, Reproductive Toxicity, Teratogenicity, and Mutagenicity. Hazardous components NTP Carcinogen IARC Carcinogen OSHA Carcinogen (Specifically Regulated) ACGIH Carcinogen Methyl methacrylate No No No Group A4 Aldehyde-amine condensate No No No No Toluene No No No Group A4 Hazardous components LD50s and LC50s Health Effects/Target Organs Methyl methacrylate Oral LD50 (RAT) = 7,800 mg/kg Oral LD50 (RABBIT) = 6,000 mg/kg Oral LD50 (RAT) = 9,400 mg/kg Inhalation LC50 (RAT, 8 h) = 3750 ppm Allergen, Irritant, Kidney, Liver, Mutagen, Nervous System, Respiratory Aldehyde-amine condensate No Records Toluene Oral LD50 (RAT) = 2.6 g/kg Oral LD50 (RAT) = 5,000 mg/kg Dermal LD50 (RABBIT) = 12,124 mg/kg Inhalation LC50 (RAT, 1 h) = ppm Inhalation LC50 (RAT, 2 h) = ppm Inhalation LC50 (RAT, 4 h) = 8000 ppm 12. ECOLOGICAL INFORMATION Behavioral, Cardiac, Central nervous system, Developmental, Ear, Irritant Ecological information: 13. DISPOSAL CONSIDERATIONS Information provided is for unused product only. Recommended method of disposal: Follow all local, state, federal and provincial regulations for disposal. Canada Transportation of Dangerous Goods - Ground ADHESIVES 14. TRANSPORT INFORMATION Page 4 of 5

5 International Air Transportation (ICAO/IATA) Adhesives Water Transportation (IMO/IMDG) ADHESIVES Canada Regulatory Information 15. REGULATORY INFORMATION CEPA DSL/NDSL Status: All components are listed on or are exempt from listing on the Canadian Domestic Substances List. United States Regulatory Information TSCA 8 (b) Inventory Status: All components are listed or are exempt from listing on the Toxic Substances Control Act Inventory. 16. OTHER INFORMATION This material safety data sheet contains changes from the previous version in sections: This product has been classified in accordance with the hazard criteria of the Controlled Products Regulation (CPR), and the MSDS contains all the information required by the CPR. Prepared by: Rena Petrides, Regulatory Affairs Specialist DISCLAIMER: The data contained herein are furnished for information only and are believed to be reliable. However, Henkel Corporation and its affiliates ( Henkel ) does not assume responsibility for any results obtained by persons over whose methods Henkel has no control. It is the user s responsibility to determine the suitability of Henkel s products or any production methods mentioned herein for a particular purpose, and to adopt such precautions as may be advisable for the protection of property and persons against any hazards that may be involved in the handling and use of any Henkel s products. In light of the foregoing, Henkel specifically disclaims all warranties, express or implied, including warranties of merchantability and fitness for a particular purpose, arising from sale or use of Henkel s products. Henkel further disclaims any liability for consequential or incidental damages of any kind, including lost profits. Page 5 of 5