MATERIAL SAFETY DATA SHEET

Transcription

1 MATERIAL SAFETY DATA SHEET 1. Product and Company Identification Material name Version # 01 LPS Micro-X NU Issue date CAS # Part Number Product use Manufacturer information Mixture C06616 A fast evaporating contact cleaner designed for the removal of dirt, moisture, dust, flux, or oxides from the internal components of electronic or precision equipment. LPS Laboratories, a division of Illinois Tool Works 4647 Hugh Howell Rd Tucker, Georgia United States / Chemtrec Hazards Identification Emergency overview DANGER CONTENTS UNDER PRESSURE. Flammable aerosol. Aerosol. Pressurized container may explode when exposed to heat or flame. Yields a flame projection at full valve opening or a flashback at any degree of valve opening. Will be easily ignited by heat, spark or flames. Potential health effects Routes of exposure Eyes Skin Inhalation Ingestion Target organs Chronic effects Signs and symptoms Inhalation. Ingestion. Skin contact. Eye contact. Contact with eyes may cause irritation. Do not get this material in contact with eyes. Irritating to skin. Do not get this material in contact with skin. Intentional misuse by concentrating and inhaling the product can be harmful or fatal. May cause irritation of respiratory tract. Prolonged inhalation may be harmful. Avoid breathing dust/fume/gas/mist/vapors/spray. Exposure by ingestion of an aerosol is unlikely. of the product may be absorbed into the body by ingestion. Irritating. May cause nausea, stomach pain and vomiting. Do not ingest. Central nervous system. Eyes. Respiratory system. Skin. Frequent or prolonged contact may defat and dry the skin, leading to discomfort and dermatitis. Symptoms are prostration, gasping, pallor, and uncoordinated movements. Symptoms may include redness, edema, drying, defatting and cracking of the skin. Symptoms of overexposure may be headache, dizziness, tiredness, nausea and vomiting. 3. Composition / Information on Ingredients CAS # Percent 2-METHYLPENTANE HFC 134A HEXANE, ALL ISOMERS 2,3-DIMETHYLBUTANE NEOHEXANE HEPTANE (N-HEPTANE) ISOPROPANOL / 8

2 CAS # Percent N-HEXANE Other components below reportable levels First Aid Measures First aid procedures Eye contact Skin contact Inhalation Ingestion tes to physician General advice Immediately flush eyes with plenty of water for at least 15 minutes. If a contact lens is present, DO NOT delay irrigation or attempt to remove the lens. Call a physician or poison control center immediately. For minor skin contact, avoid spreading material on unaffected skin. If skin irritation occurs: Get medical advice/attention. Wash clothing separately before reuse. Move to fresh air. Oxygen or artificial respiration if needed. Do not use mouth-to-mouth method if victim inhaled the substance. Induce artificial respiration with the aid of a pocket mask equipped with a one-way valve or other proper respiratory medical device. Call a physician or poison control center immediately. IF SWALLOWED: Immediately call a POISON CENTER or doctor/physician. Never give anything by mouth to a victim who is unconscious or is having convulsions. Rinse mouth thoroughly. Do not induce vomiting without advice from poison control center. If vomiting occurs, keep head low so that stomach content doesn't get into the lungs. Induce artificial respiration with the aid of a pocket mask equipped with a one-way valve or other proper respiratory medical device. Symptoms may be delayed. Ensure that medical personnel are aware of the material(s) involved, and take precautions to protect themselves. Immediate medical attention is required. Show this safety data sheet to the doctor in attendance. 5. Fire Fighting Measures Flammable properties Extinguishing media Suitable extinguishing media Unsuitable extinguishing media Protection of firefighters Specific hazards arising from the chemical Protective equipment for firefighters Fire fighting equipment/instructions Specific methods Explosion data Sensitivity to static discharge Sensitivity to mechanical impact Flammable by WHMIS criteria. Heat may cause the containers to explode. Ruptured cylinders may rocket. Vapors may travel considerable distance to a source of ignition and flash back. Dry chemical powder. Water Spray or Fog. Foam. Do not use a solid water stream as it may scatter and spread fire. Contents under pressure. Pressurized container may explode when exposed to heat or flame. Firefighters should wear full protective clothing including self contained breathing apparatus. Firefighters must use standard protective equipment including flame retardant coat, helmet with face shield, gloves, rubber boots, and in enclosed spaces, SCBA. Containers should be cooled with water to prevent vapor pressure build up. For massive fire in cargo area, use unmanned hose holder or monitor nozzles, if possible. If not, withdraw and let fire burn out. Cool containers exposed to flames with water until well after the fire is out. ne known. 6. Accidental Release Measures Personal precautions Environmental precautions Keep unnecessary personnel away. Consider initial downwind evacuation for at least 500 meters (1/3 mile). Do not touch damaged containers or spilled material unless wearing appropriate protective clothing. Keep people away from and upwind of spill/leak. Keep out of low areas. Pay attention to flashback. Ventilate closed spaces before entering them. Prevent further leakage or spillage if safe to do so. Do not contaminate water. 2 / 8

3 Methods for containment Methods for cleaning up Other information 7. Handling and Storage Handling Storage ELIMINATE all ignition sources (no smoking, flares, sparks or flames in immediate area). Stop leak if you can do so without risk. Move the cylinder to a safe and open area if the leak is irreparable. Many gases are heavier than air and will spread along ground and collect in low or confined areas (sewers, basements, tanks). Keep out of low areas. This material is classified as a water pollutant under the Clean Water Act and should be prevented from contaminating soil or from entering sewage and drainage systems which lead to waterways. Stop the flow of material, if this is without risk. Isolate area until gas has dispersed. Clean up in accordance with all applicable regulations. For waste disposal, see section 13 of the MSDS. Clean up in accordance with all applicable regulations. Pressurized container: Do not pierce or burn, even after use. Do not spray on a naked flame or any other incandescent material. Do not smoke while using or until sprayed surface is thoroughly dry. Do not cut, weld, solder, drill, grind, or expose containers to heat, flame, sparks, or other sources of ignition. All equipment used when handling the product must be grounded. Ground and bond containers when transferring material. Do not use if spray button is missing or defective. Do not re-use empty containers. Do not breathe mist or vapor. Do not get this material in contact with eyes. Do not get this material in contact with skin. Do not get this material on clothing. Do not use in areas without adequate ventilation. Avoid prolonged exposure. Wash thoroughly after handling. Level 3 Aerosol. 8. Exposure Controls / Personal Protection Occupational exposure limits US. ACGIH Threshold Limit s Keep locked up. Contents under pressure. The pressure in sealed containers can increase under the influence of heat. Do not expose to heat or store at temperatures above 120 F/49 C as can may burst. Do not puncture, incinerate or crush. Do not handle or store near an open flame, heat or other sources of ignition. This material can accumulate static charge which may cause spark and become an ignition source. Avoid exposure to long periods of sunlight. Store in a well-ventilated place. Keep in an area equipped with sprinklers. Keep away from food, drink and animal feedingstuffs. Keep out of the reach of children. US. ACGIH. BEIs. Biological Exposure Indices BEI BEI 50 ppm 40 mg/l 0.4 mg/l Canada. Alberta OELs (Occupational Health & Safety Code, Schedule 1, Table 2) 2050 mg/m3 3 / 8

4 Canada. Alberta OELs (Occupational Health & Safety Code, Schedule 1, Table 2) 1640 mg/m3 984 mg/m3 492 mg/m3 176 mg/m3 50 ppm Canada. British Columbia OELs. (Occupational Exposure Limits for Chemical Substances, Occupational Health and Safety Regulation 296/97, as amended) 20 ppm Canada. Ontario OELs. (Control of Exposure to Biological or Chemical Agents) 50 ppm Canada. Quebec OELS. (Ministry of Labor - Regulation Respecting the Quality of the Work Environment) 2050 mg/m3 4 / 8

5 Canada. Quebec OELS. (Ministry of Labor - Regulation Respecting the Quality of the Work Environment) 1640 mg/m mg/m3 983 mg/m3 176 mg/m3 50 ppm US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR ) Engineering controls Personal protective equipment Eye / face protection Skin protection Respiratory protection 9. Physical & Chemical Properties Appearance Physical state Form Color Odor Odor threshold ph Vapor pressure Vapor density 3 Boiling point Melting point/freezing point Solubility (water) PEL PEL PEL 2000 mg/m3 980 mg/m mg/m3 Ensure adequate ventilation, especially in confined areas. Wear safety glasses with side shields (or goggles). Wear appropriate chemical resistant clothing. Chemical resistant gloves. Use a positive-pressure air-supplied respirator if there is any potential for an uncontrolled release, exposure levels are not known, or any other circumstances where air-purifying respirators may not provide adequate protection. If permissible levels are exceeded use NIOSH mechanical filter / organic vapor cartridge or an air-supplied respirator. Clear. Liquid. Gas. Aerosol. Clear water-white Mild. Solvent mm Hg Calculated F (60.5 C) < 5 % w/w Specific gravity 25 C Relative density Flash point Flammability limits in air, upper, % by volume Flammability limits in air, lower, % by volume Auto-ignition temperature F ( C) Tag Closed Cup 7 % 1.2 % F (306 C) 5 / 8

6 VOC Evaporation rate 74 % per U.S. State and Federal Consumer Product Regulations < 1 BuAc Viscosity < 3 25 C Percent volatile 100 % Partition coefficient (n-octanol/water) Other data Flammability class > 1 Flammable IB estimated 10. Chemical Stability & Reactivity Information Chemical stability Conditions to avoid Incompatible materials Hazardous decomposition products Possibility of hazardous reactions 11. Toxicological Information Local effects Chronic effects Carcinogenicity ACGIH Carcinogens ISOPROPANOL (CAS ) 12. Ecological Information Persistence and degradability 13. Disposal Considerations Disposal instructions Contaminated packaging 14. Transport Information TDG Proper shipping name Hazard class UN number Marine pollutant Special provisions Labels required Packaging exceptions Packaging non bulk Packaging bulk IATA UN number UN proper shipping name Transport hazard class(es) Environmental hazards Labels required IMDG UN number UN proper shipping name Transport hazard class(es) Risk of explosion. Risk of ignition. Heat, flames and sparks. Aerosol containers are unstable at temperatures above 49 C. Strong oxidizing agents. Hydrogen fluoride. Carbon oxides. Hazardous polymerization does not occur. Irritating to eyes. Irritating to skin. Prolonged inhalation may be harmful. t expected to be hazardous by WHMIS criteria. A4 t classifiable as a human carcinogen. Collect and reclaim or dispose in sealed containers at licensed waste disposal site. Contents under pressure. Do not puncture, incinerate or crush. Dispose in accordance with all applicable regulations. Empty containers should be taken to an approved waste handling site for recycling or disposal. Do not re-use empty containers. Aerosols, flammable, MARINE POLLUTANT UN1950 N ne ne UN1950 Aerosols, flammable UN1950 Aerosols, flammable, MARINE POLLUTANT 6 / 8

7 Environmental hazards Marine pollutant Labels required IATA; IMDG; TDG Marine pollutant General 15. Regulatory Information Canadian regulations WHMIS status WHMIS classification WHMIS labeling IMDG Regulated Marine Pollutant. This product has been classified in accordance with the hazard criteria of the CPR and the MSDS contains all the information required by the CPR. Controlled A - Compressed Gas B5 - Flammable Aerosols D2A - Other Toxic Effects-VERY TOXIC D2B - Other Toxic Effects-TOXIC Inventory status Country(s) or region Inventory name On inventory (yes/no)* Australia Australian Inventory of Chemical Substances (AICS) Canada Canada China Europe Europe Japan Korea New Zealand Philippines United States & Puerto Rico Domestic Substances List (DSL) n-domestic Substances List (NDSL) Inventory of Existing Chemical Substances in China (IECSC) European Inventory of Existing Commercial Chemical Substances (EINECS) European List of tified Chemical Substances (ELINCS) Inventory of Existing and New Chemical Substances (ENCS) Existing Chemicals List (ECL) New Zealand Inventory Philippine Inventory of Chemicals and Chemical Substances (PICCS) Toxic Substances Control Act (TSCA) Inventory *A "" indicates that all components of this product comply with the inventory requirements administered by the governing country(s) 7 / 8

8 16. Other Information Further information HMIS ratings Health: 2* Flammability: 4 Physical hazard: 2 NFPA ratings Health: 2 Flammability: 3 Instability: 0 Disclaimer This data sheet contains changes from the previous version in section(s): HMIS is a registered trade and service mark of the NPCA. The information in the sheet was written based on the best knowledge and experience currently available. Product and Company Identification: Product Uses Composition / Information on Ingredients: Ingredients Physical & Chemical Properties: Multiple Properties Transport Information: Product Shipping Name/Packing Group Regulatory Information: United States 8 / 8