TGG 8 hour mg/m CASnumber. TGG 15 min. Name of substance

Size: px

Start display at page:

Download "TGG 8 hour mg/m CASnumber. TGG 15 min. Name of substance"

Virginia Tyler
5 years ago
Views:

Information card 7 Limit Values The following chart shows limits of common hazardous gases in shipping containers. For part of these gases there is a legal limit.

1 Information card 7 Limit Values The following chart shows limits of common hazardous gases in shipping containers. For part of these gases there is a legal limit. Substances for which no legal limit exists, the limit (formerly MAC value) used is the one that was in force until January 1, 2007 in the Netherlands. It gives the following summary: Name of substance Ammonia* Benzene* ydrocyanic acid* Chloropicrin** 1,2-Dichloroethane* Formaldehyde* Phosphine* Carbon dioxide* Carbon monoxide* Methyl bromide** Sulfuryl fluoride** CASnumber Styrene** Toluene* Xylene* TGG 8 hour mg/m 3 14 (ppm) (20) 3,25 (1) 1 (0,9) 0,7 7 (1,5) 0,15 0, (5000) 29 (25) 1 (0,3) 10 (2,5) 86 (20) 150 (40) 210 (48) TGG 15 min mg/m ,5 0, Oxygen*** 19 21% Explosive limit Maximum 10% Page 1 of 5

2 Explanation of the chart: * Legal limit under the Working Conditions Decree (Articles 4.3 and 4.16) ** Applicable MAC limit until January 1, Sometimes called the indicative limit. *** Regarding the oxygen content, the Working Conditions Decree uses a concentration below 18 volume percent as a minimum. owever below 19 volume percent working becomes quite difficult because the oxygen exchange in the blood is hampered. ealthy Transport (Gezond Transport) recommends a minimum of 19 volume percent. CAS-number To facilitate unequivocal identification every substance has had a so-called CASnumber added, i.e. the number under which the Chemical Abstract Service registers the substance. TWA Time Weighted Average. In addition to the maximum allowable concentration for an exposure time of 8 hours a day, for some substances a limit is also set for short-term exposure of up to 15 minutes. : Skin absorption Substances that are absorbed relatively easily by the skin, which could mean a substantial contribution to the total internal exposure, are designated with an. In addition to measures against inhalation of these substances, appropriate measures need to be taken to avoid skin contact. Page 2 of 5

3 Information about limits Public and private limits In January 2007, a revised limit system was introduced. The old system of Maximum Allowable Concentrations (MAC-values) has been replaced by legal limits. These are set by the government and published on Industry needs to draw up private limits for other substances; working with these substances should not lead to immediate or long-term health problems for the employee or his offspring. What is a limit value? A limit value is the permissible limit of concentration of a substance in the breathing zone of a worker. The limit indicates that during a forty-year exposure there is no risk of health hazards. The limit can be indicated in a Time Weighted Average (TWA) or a Ceiling value (C.) The Time Weighted Average (TWA) is usually based on an average over an eight-hour working day (TWA 8 hours). During the working day the limit TWA 8 hours- may not be exceeded. For some substances with immediate toxic effects time weighted averages of 15 minutes have been set (TWA 15 minutes). TWA 15 minutes is the limit for short-term peak exposure, when during the rest of the day no or negligible exposure to hazardous substances occurs. If a TWA 15 minutes has not been set for a substance the labor inspectorate uses the limit of the TWA 8 hour multiplied by a factor 2 as a guideline. This does not apply for carcinogenic, mutagenic or reprotoxic Substances. A limit such as a ceiling value (C) indicates that this limit should not be exceeded at any time. De limits have been established to cover situations where hazardous substances are inhaled. They do not offer protection from exposure in other ways such as through the skin and by ingestion. When a substance (such as benzene) is known to be easily absorbed by the skin, the limit value gets a notation for Skin exposure. On the website of SER (Social and Economic Council of the Netherlands, it is possible to look up the CAS number through the substance name and what is the current limit. On this website the indicative limits are also mentioned. These are the former MAC limits and limits that apply in other European countries. Carcinogenic, mutagenic and reprotoxic substances Carcinogenic substances can cause cancer, mutagenic substances can change the genetic material of man and reprotoxic substances can have a negative effect on fertility and the unborn child. Carcinogenic, reprotoxic and mutagenic substances are subject to a different approach. These substances lack a safe threshold. The lowest possible exposure (none) should always be aimed for. And here the possibility to go twice the limit during a brief exposure does not apply. Page 3 of 5

4 Insufficient protection Limits are generally geared to providing safety to a healthy population of male employees. A limit may not offer full protection if employees carry out heavy physical labor. In determining limits, figures are based on an average respiratory minute volume of employees. owever, when performing heavy physical labor more air than on average is inhaled which could cause an excessive amount of substance to be absorbed. The same effect is caused when working hours exceed 8 hours per day. In addition limits offer insufficient protection to special groups of employees who have a reduced capability, such as pregnant women and young people. Combined exposure (addition rule) Limits have been established for single substances. When exposed to a combination of substances of which it is known that the individual components have the same toxic effect on an organ system, the so-called addition rule applies when testing the limits. With the addition rule the sum of all the individual exposure situations, as a fraction of the individual limits, has to be less than 1. In other words: (C 1 / limit 1 ) + (C 2 / limit 2 ) + (C 3 / limit 3 ) + (C n / limits) < 1 Where: - C n is the exposure concentration to substance n - limit n is the limit for substance n This is for instance the case with exposure to various organic solvents, such as the combination of exposure to toluene, xylene, alkene, methyl ethyl ketone, gasoline, kerosene, alcohols, ketones, aldehydes, etc. The evaporation problem in shipping containers is rarely a question of one single hazardous substance. Deployment of specialists When exposure for employees varies during a working day in terms of diversity of substances or in terms of duration of the exposure or when a brief exposure of 15 minutes occurs more than once per working day, it is recommended to have the risk assessed by a specialist (for example an occupational health specialist). Page 4 of 5

5 Examples of calculations - Brief exposure On a working day an employee opens one shipping container, which is known to contain methyl bromide. The exposure time is << 15 minutes. During the rest of the day no more exposure to hazardous substances takes place. A TWA has not been established. The limit that is tested is double the TWA- 8 hours. It should be noted that in the limit an is shown. This means that skin absorption can contribute substantially to internal exposure. Proper skin protection is (necessary) even during brief exposure. - Brief exposure to a carcinogenic substance On a working day an employee opens one shipping container, which is known to contain benzene. Exposure is < 15 minutes. During the rest of the day no more exposure to hazardous substances takes place. Because benzene is a carcinogenic substance it remains, in spite of the brief exposure, at a maximum of 3,25 mg/m 3 (TWA-8 hours). Nevertheless the employer has the duty to keep exposure to benzene to a minimum (avoid it altogether). - Combined exposure (addition rule) An employee offloads two similar shipping containers using a forklift. e does this throughout his working day. It is known that the shipping containers contain various solvents (including toluene and xylene). In a situation such as this the addition rule applies. - Combined exposure in combination with heavy physical labor An employee manually offloads two similar shipping containers. e does this throughout his working day. It is known that the shipping containers contain various solvents (including toluene and xylene). In a situation such as this the addition rule applies. In addition, the manual offloading of a container is physically demanding work. It must therefore be taken into account that the current limits do not offer adequate protection. What percentage of the limit does offer adequate protection has not been established. Page 5 of 5

SAFETY DATA SHEET Lead Stop

SAFETY DATA SHEET Lead Stop SECTION 1 Identification Product Name: Lead Stop SDS Number: DCI-061 TiO2 Recommended use: Paint Stripping. Restrictions on use: Use only as directed Manufactured for: DUMOND