Material Safety Data Sheet

Transcription

1 Page: 1 of 1. IDENTIFICATION OF THE MATERIAL AND SUPPLIER TORK PREMIUM SOAP FOAM MILD Product Name Company Name Address Emergency Tel. Telephone/Fax Number Recommended Use Other SCA AUSTRALASIA - AWAY FROM HOME Westall Road Springvale Victoria 3171 Australia (BH) Tel: Fax: Skin cleanser. 2. HAZARDS IDENTIFICATION Hazard Classification NEW ZEALAND: SCA Hygiene Australasia AFH Level 1, 6 Alderman Drive Henderson 8, Auckland Phone:: Fax: Emergency Advice: (BH) or Mobile: Not classified as Hazardous according to criteria of National Occupational Health & Safety Commission, Australia (NOHSC). Not classified as Dangerous Goods according to the Australian Code for the Transport of Dangerous Goods by Road and Rail. Classified as Hazardous according to the Hazardous Substances (Minimum Degrees of Hazard) Regulations 2001, New Zealand. Not classified as Dangerous Goods for transport according to the New Zealand Standard NZS 433:2007 Transport of Dangerous Goods on Land. HSNO Classification: 6.3B - Substance that is mildly irritating to the skin 8.3A - Substance that is corrosive to ocular tissue Hazard statement codes: H316 Causes mild skin irritation. H318 Causes serious eye damage. Precautionary statement codes - Prevention: P102 Keep out of reach of children. -This statement applies only where the substance is available to the general public. P103 Read label before use. -This statement applies only where the substance is available to the general public. P104 Read Safety Data Sheet before use. P280 Wear protective eye protection and face protection. Precautionary statement codes - Response: P101 If medical advice is needed, have product container or label at hand. -This statement applies only where the substance is available to the general public. SKIN P332+P313 If skin irritation occurs: Get medical advice/ attention. EYE P30+P31+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. P310 Immediately call a POISON CENTER or doctor/physician. Precautionary statement codes - Disposal: P01 In the case of a substance that is in compliance with a HSNO approval other than a Part 6A (Group Standards) approval, a label must provide a description of one or more appropriate and achievable methods for the disposal Print Date: 1/03/2012

2 Page: 2 of of a substance in accordance with the Hazardous Substances (Disposal) Regulations This may also include any method of disposal that must be avoided. See Section 13 for disposal details. 3. COMPOSITION/INFORMATION ON INGREDIENTS Ingredients 4. FIRST AID MEASURES Inhalation Ingestion Skin Eye First Aid Facilities Advice to Doctor Other Name CAS Proportion Hazard Symbol Risk Phrase Sodium laureth sulfate Citric acid 2-Phenoxyethanol Benzoic acid Ingredients determined not to be hazardous % <1 % Xi R <1 % <0.1 % Balance If inhaled, remove affected person from contaminated area. Keep at rest until recovered. If symptoms persist seek medical attention. Do not induce vomiting. Wash out mouth thoroughly with water. If symptoms develop seek medical attention. Wash affected area thoroughly with soap and water. If symptoms develop seek medical attention. If in eyes, hold eyelids apart and flush the eyes continuously with running water. Continue flushing for several minutes until all contaminants are washed out completely. Seek medical attention. Eyewash and normal washroom facilities. Treat symptomatically.. FIRE FIGHTING MEASURES Suitable Extinguishing Media Hazards from Combustion Products Specific Hazards Precautions in connection with Fire For advice in an emergency, contact a Poisons Centre (Phone Australia ; New Zealand 0800 POISON / ) or a doctor at once. Use extinguishing media suitable for surrounding environment. Under fire conditions this product may emit toxic and/or irritating fumes and gases including carbon monoxide and carbon dioxide. This product is non-combustible. However heating can cause expansion or decomposition leading to violent rupture of containers. Fire fighters should wear Self-Contained Breathing Apparatus (SCBA) operated in positive pressure mode and full protective clothing to prevent exposure to vapours or fumes. Water spray may be used to cool down heat-exposed containers. 6. ACCIDENTAL RELEASE MEASURES Emergency Procedures 7. HANDLING AND STORAGE Precautions for Safe Handling Conditions for Safe Storage Wear appropriate personal protective equipment and clothing to minimise exposure. Increase ventilation. If possible contain the spill. Place inert absorbent material onto spillage. Collect the material and place into a suitable labelled container. Do not dilute material but contain. Dispose of waste according to the applicable local and national regulations. If contamination of sewers or waterways occurs inform the local water and waste management authorities in accordance with local regulations. Use only in a well ventilated area. Keep containers sealed when not in use. Prevent the build up of mists or vapours in the work atmosphere. Avoid inhalation of vapours and mists, and skin or eye contact. Maintain high standards of personal hygiene i.e. Washing hands prior to eating, drinking, smoking or using toilet facilities. Store in a cool, dry, well-ventilated area, out of direct sunlight. Store in suitable, labelled containers. Keep containers closed when not in use. Ensure that storage conditions comply with applicable local and national regulations. Print Date: 1/03/2012

3 Page: 3 of Storage Temperatures Store above freezing. Store at temperature not greater than 30 C. 8. EXPOSURE CONTROLS/PERSONAL PROTECTION National Exposure Standards Biological Limit Values Engineering Controls Respiratory Protection Eye Protection Hand Protection Body Protection No exposure value assigned for this specific material by the National Occupational Health and Safety Commission (NOHSC), Australia or the Occupational Safety and Health Service (OSH) of the New Zealand Department of Labour. No biological limits allocated. Provide sufficient ventilation to keep airborne levels as low as possible. Where vapours or mists are generated, particularly in enclosed areas, and natural ventilation is inadequate, a local exhaust ventilation system is required. If engineering controls are not effective in controlling airborne exposure then an approved respirator with a replaceable mist filter should be used. Reference should be made to Australian/New Zealand Standards AS/NZS 171, Selection, Use and Maintenance of Respiratory Protective Devices; and AS/NZS 1716, Respiratory Protective Devices, in order to make any necessary changes for individual circumstances. Safety glasses with side shields or chemical goggles should be worn. Final choice of appropriate eye/face protection will vary according to individual circumstances. Eye protection devices should conform with Australian/New Zealand Standard AS/NZS Eye Protectors for Industrial Applications. Wear gloves of impervious material. Final choice of appropriate gloves will vary according to individual circumstances i.e. methods of handling or according to risk assessments undertaken. Reference should be made to AS/NZS : Occupational protective gloves - Selection, use and maintenance. Suitable protective work wear, e.g. cotton overalls buttoned at neck and wrist is recommended. Chemical resistant apron is recommended where large quantities are handled. 9. PHYSICAL AND CHEMICAL PROPERTIES Low viscous foaming yellow liquid Appearance Odour Melting Point Boiling Point Solubility in Water ph Value Vapour Pressure Vapour Density (Air=1) Viscosity Density Flash Point Flammability Auto-Ignition Temperature Flammable Limits - Lower Flammable Limits - Upper Pleasant Soluble.0 (approximate) (in a 10% solution) <10 cps (approximate) 1.03 g/cm3 (approximate) Non-combustible 10. STABILITY AND REACTIVITY Stable under normal conditions of storage and handling. Chemical Stability Conditions to Avoid Extremes of temperature and direct sunlight. Protect from freezing. Print Date: 1/03/2012

4 Page: 4 of Incompatible Materials Hazardous Decomposition Products Hazardous Polymerization Strong oxidising agents and alkalis. Under fire conditions this product may emit toxic and/or irritating fumes, smoke and gases including carbon monoxide and carbon dioxide. Will not occur. 11. TOXICOLOGICAL INFORMATION Toxicology Inhalation Ingestion Skin Eye Chronic Effects No toxicity data available for this product. Inhalation of product mists or vapours may cause irritation of the nose, throat and respiratory system. Ingestion of this product may irritate the gastric tract causing nausea and vomiting. May be irritating to skin. The symptoms may include redness, itching and swelling. May be irritating to eyes. The symptoms may include redness, itching and tearing. None known 12. ECOLOGICAL INFORMATION No ecological data are available for this material. Ecotoxicity Persistence / Degradability Mobility Environ. Protection Soluble in water. 13. DISPOSAL CONSIDERATIONS Disposal Considerations Prevent this material entering waterways, drains and sewers. Product Disposal: Product wastes are controlled wastes and should be disposed of in accordance with all applicable local and national regulations. This product can be disposed through a licensed commercial waste collection service. In this specific case the product is water-based/water-soluble and therefore can be sent through a Waste Water Treatment Plant and after treatment can be discharged into environment through the sewerage or drainage systems as authorized. Do not dispose directly into the sewerage system. Do not discharge into drains or watercourses or dispose where ground or surface waters may be affected. Personal protective clothing and equipment as specified in Section 8 of this SDS must be worn during handling and disposal of this product. The ventilation requirements as specified in the same section must also be followed, and the precautions given in Section 7 of this SDS regarding handling must also be followed. In New Zealand, the disposal agency or contractor must comply with the New Zealand Hazardous Substances (Disposal) Regulations Further details regarding disposal can be obtained on the EPA New Zealand website under specific group standards. Container Disposal: The container or packaging must be cleaned and rendered incapable of holding any substance. It can then be disposed of in a manner consistent with that of the substance it contained. In this instance the packaging can be disposed through a commercial waste collection service. Alternatively, the container or packaging can be recycled if the hazardous residues have been thoroughly cleaned or rendered non-hazardous. In New Zealand, the packaging (that may or may not hold any residual substance) that is lawfully disposed of by householders or other consumers through a public or commercial waste collection service is a means of compliance with regulations. Print Date: 1/03/2012

5 Page: of 14. TRANSPORT INFORMATION Transport Not classified as Dangerous Goods according to the Australian Code for the Transport of Dangerous Goods by Road and Rail. (7th edition) Not classified as Dangerous Goods for transport according to the NZS 433:2007 Transport of Dangerous Goods on Land. 1. REGULATORY INFORMATION Regulatory Poisons Schedule National and or International Regulatory HSNO Approval Number 16. OTHER INFORMATION Date of preparation or last revision of MSDS Not classified as Hazardous according to criteria of National Occupational Health & Safety Commission (NOHSC), Australia. Not classified as a Scheduled Poison according to the Standard for the Uniform Scheduling of Medicines and Poisons (SUSMP). Not Scheduled Classified as Hazardous according to the New Zealand Hazardous Substances (Minimum Degrees of Hazard) Regulations All components of this product are listed on the New Zealand Inventory of Chemicals (NZIoC) or exempted. Group Standard: Additives, Process Chemicals and Raw Materials (Subsidiary Hazard) Group Standard 2006 HSR00203 MSDS Reviewed: February 2012 Supersedes: November End Of MSDS... Copyright ACOHS Pty Ltd Copyright in the source code of the HTML, PDF, XML, XFO and any other electronic files rendered by an Infosafe system for Infosafe MSDS displayed is the intellectual property of Acohs Pty Ltd. Copyright in the layout, presentation and appearance of each Infosafe MSDS displayed is the intellectual property of Acohs Pty Ltd. The compilation of MSDS's displayed is the intellectual property of Acohs Pty Ltd. Copying of any MSDS displayed is permitted for personal use only and otherwise is not permitted. In particular the MSDS's displayed cannot be copied for the purpose of sale or licence or for inclusion as part of a collection of MSDS without the express written consent of Acohs Pty Ltd. Print Date: 1/03/2012