Installation Instructions

Transcription

1 WHAT S IN THE BOX Charger RAM mount Not included in the box Kayak sensor Paddle sensor Rail mount PADDLE SENSOR INSTALLATION Step 1: Placement Use the right blade side of your paddle, the rail should be placed as close to the middle of the shaft as possible. Step 2: Cleaning Clean the area where you will attach the paddle sensor to. * for best results use an alchohol pad. Step 3: Positioning the rail Position the rail so that the rail ramp side points to the right blade Middle of the paddle - Center line Rail ramp - Right blade side

2 The center line of the rail sould align to the top edge of the right blade Step 4: Attaching the rail to the paddle Peel the film off the double sided tape. Position the rail according to the instructions in step 4. Once properly positioned, apply firm and equal pressure to the mount for 60 consecutive seconds. Apply firm and equal pressure Step 5: Sliding the sensor Slide the sensor onto the mount with the LEDs pointing to the right blade.

3 Step 6: Double secure it FRONT Hook the double securing band around the paddle sensor and shaft KAYAK SENSOR INSTALLATION Step 1: Placement Place the rail on the bow parallel to the boat, with the LEDs facing the bow. On touring or sea kayaks - it is best to place the sensor within arm s reach. On surfskis - it is best to place the sensor as close to the foot pegs as possible. Sea Kayak Surf - Ski Bungee cord area Foot pegs area * preferable option Surf - Ski Step 2: Cleaning Clean the area where you will attach the kayak sensor to. * for best results use an alchohol pad.

4 Step 3: Positioning the rail Position the rail so that the rail ramp side points to the bow FRONT Rail ramp - bow Stern - Center line Step 4: Attaching the rail to the kayak Peel the film off the double sided tape. Attach the rail mount parallel to the boat, as close to it center as possible. Once properly positioned, attach the mount while applying firm and equal pressure for 60 consecutive seconds. *For best results wait 24 hours before entering the water. 1 Attach the mount as close to it center as possible 2 Apply firm and equal pressure

5 Step 5: Sliding the sensor Slide the sensor with the LEDs pointing to the bow Step 6: Double secure it Slide the sensor onto the mount, use the carabiner to double secure it to the bungee cords on your boat. THE RAM MOUNT The RAM mount (Not included in the box - you can buy it separately in our online shop) allows you to position your phone conveniently in your line of sight. RAM MOUNT INSTALLATION Step 1: Positioning Select a relatively flat area of the kayak that will allow you to see the phone s screen without interfering with your paddling.

6 Step 2: Cleaning Clean the area where you will attach the RAM mount to. * for best results use an alchohol pad. Step 3: Attach the RAM mount Position the mount and attach it while applying firm pressure for 60 consecutive seconds *For best results wait 24 hours before entering the water. Apply firm and equal pressure Step 4: Positioning your phone Using your own waterproof case or bag, place your phone in the RAM mount and adjust the angle for optimal viewing.